Go to a parts store and buy a Haynes Manual.
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
Yes , the Chevy Corvette has always been rear wheel drive
Begin by removing the water supply hoses from your 1989 Chevy heater core. Remove the heater core retaining bolts. The heater core can be removed.
inside the fuel tank
For starters try activating the wiper switch...
1989 was the first year for corvette to have the air bag.
i need help on how to replace the pin in my 1989 Chevy beretta gt please help me
The 1989 Chevrolet heater core can be found behind the kick plate. You will need to remove the passenger side kick plate in order to access the heater core.
10w30 in most climates should do fine.
You can adjust your 1989 Chevy Corvette emergency brake into different ways. The emergency brake will have an adjustment bolt on the brake pad. The emergency brake cable can be adjusted to shorten or lengthen the cable.
inside dashboard on passenger side
it is next to the firewall near the heater coil
under the right side dash. you remove heater lower cover heater core right behind cover there are some hiden screws close to the fire wall good luck
On a 1989 Chevy Celebrity the heater hose leaves the water pump via a hose barb then runs along the top of the passenger side frame rail and then into the heater core. The heater core is in the firewall below the blower fan on the passenger side of the car. The return hose leaves the heater core and runs along the firewall then to the water outlet below the thermostat.
Low coolant level? Cooling system airbound? Bad thermostat? Water pump not circulating coolant? Heater control cable not working?
Whatever 1 is the easyest to get to.
that why we pray! just to make it today!
The dash and fire wall need to be taken out.
600.00 to 900.00
I would say that your heater core is ok...it sounds like you have a bled door promlem in the dash.