answersLogoWhite
Ford Thunderbird

How do you replace the ignition module on a Ford Tempo?


Top Answer
User Avatar
Wiki User
2015-07-15 21:04:09
2015-07-15 21:04:09

Ignition module on Ford Tempo. First things first, pull the interior trim panel off from under steering wheel, this should expose the screws from the panel on the top part of the column. You will need an inverted Torx bit to remove the old module, be sure the key is in the ACCESSORY position. The new module after market or ford part should be preset in this position as well. be sure the contacts or clean in the column and plug the new one in, pretty simple once the panels are removed and visible.

Ford Tempo uses TFI ignition, 4-cylinders used a Dist. mounted module. V-6's may be on the Dist. too. Or may be remote mounted.

Related Questions

User Avatar

What engine? Ford contour 2.0L DOHC eng. distributorless ignition are controlled by the main PCM There is an ignition module on the 99 contour 2.0 with automatic transmission. It is shown in the schematics for this model.

User Avatar

How do you replace the PCM ON A 1994 Ford Tempo GL?

User Avatar

The 1993 Ford Taurus ignition module is located behind the dashboard. The ignition module, can be found on the drivers side of the dashboard.

User Avatar

The 1995 Ford Ranger ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

User Avatar

You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.