0
How do you replace the ignition switch on a 2001 grand vitera 4wd?
Wiki User
∙ 15y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove and replace the ignition switch on a 1995 Dodge Grand Caravan?
You will need to remove the retaining ring at the top of your 1995 Dodge Grand Caravan ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you replace the ignition switch on a mercury grand marquis?
It's located on the steering column 2 screws unplug the harnest
How do you replace the ignition switch on a 1993 Pontiac Grand Am?
It's really easy the switch is in the steering colume.
How do you replace an ignition switch on a 1992 Pontiac Grand Prix?
The switch is on the steering column about 18 inches from the floor under the dash. There are 2 screws that hold it on.
Your grand am ignition wont turn off?
change ignition switch and/or tumbler
Blower on 97 grand prix only works on high lights also go out?
It's the ignition switch. Replace it. All will be well.
How do you replace the fan control switch on a 2002 Grand Prix?
"How do you replace the fan control switch on a 2002 Grand Prix?"
How to replace the ignition switch on 2002 Pontiac grand prix?
Replacing a steering column ignition switch on a 2002 Pontiac Grand Prix is not considered a major repair. The task is considered easy but if done wrong could be dangerous. It is best to refer to vehicle manual for the car to ensure proper direction is given.
Where is the ignition switch on a 2004 Pontiac Grand Am?
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
Where is the ignition switch located on a 91 Pontiac grand am?
it is located on the steering column
1999 grand prix fan only works on high settings?
Bad ignition switch.... took me forever and lots of money to find. Replace it and the fan will be fixed.
How do you replace the ignition on a Mercury Grand Marquis?
For a 1988 Mercury Marquis remove bottom shroud from steering column (5 Philips head screws). There is a wire running from the ignition switch to the left side of the steering column; detach it from the coupler (This can be done without a tool). Turn key to ON position until the panel lights come on. There is a small pin near the bottom of the key lock; push it in and pull the ignition switch out (don't panic if the wire seems to be stuck; it will come out). To replace, turn new ignition switch to same position. Push pin on the ignition switch in while sliding it back into the steering column. Reconnect wire and then replace shroud.
