Want this question answered?
front- 36mm
Much better to replace the whole axle, look at www.happywrenching.com for a guide on how to replace an axle in a Honda Odyssey
To replace the axle on a 1993 Honda Civic the axle nut has to come off. The hub assembly also will need to be pulled back so the axle can be pulled from the transmission.
how hard is it to replace a rear wheel bearing 1999 Honda crv. this crv does not have rear axle's in it. thank you
There are three weights used: GVWR and FRONT AXLE and REAR AXLE. For each vehicle this information is located by opening the driver's door and looking on the door jam (near latch) for the empty weight. My GVWR (Gross Vehicle Weight Rating) for my '87 Prelude is 3340 lbs. Front axle weight is higher than the rear axle due to the engine up front.
The rear axle bearings on a Honda 300ex are replaced by first removing the rear wheel. The bearing cap and retaining ring are then removed and the bearing is then pulled from its housing.
removing an axle from 98 Honda accord
When an axle breaks on a 1994 Honda Civic it is less expensive to replace it rather than repair it. Replacement axles in labor costs under $300 per side.
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Did you get an alignment after replacing the axle?
Jack up the Odyessy. Remove the wheel and the brake caliper. Take the brake rotor off. Remove the axle nut cover, and the cotter pin. Remove the axle housing. Replace the inner and outer bearings as well as the races.
Replace axle on 2001 buick Lesabre