Observe mounting location of the side/door mirror. This mirror is fastened by screws to the outsed of the door by screws from the inside of the door.
On the opposite side of where this mirror is attached is usually a plastic triangulsr cover, hiding these fasteners/screws.
Carefully pry this cover towards you from the top and or the right gently while "feeling" for where there is the most resistance from the plastic cover.
Locate by "feel" where this resistance is and genlty place pulling force to free it.
Do this gently for the improper directing the pulling force will break the cover.
Usually, there is a hook behind this cover and they are molded together.
Good luck and take all the time you WANT and NEED.
# Remove the door trim panel and watershield.Disconnect the electrical connector from the mirror # Remove the retaining nuts and detach the mirror from vehicle
Very simple just remove the plastic cover on the inside of the mirro then remove the 3 ten mm nuts and unplug the connector pull out the mirror and your done
All you have to do is remove the black cover on the inside corner be careful as it is clipped and it is easy to break..The nuts holding the mirror are 8mm just remove them..Disconnect the wire connector and it pops right out...
Remove the inside door panel of your 1993 Chevrolet Lumina. Remove the passenger mirror wiring harness. Remove the passenger mirror retaining bolts. Reverse the process to install the new passenger mirror.
first remove the screws in the door panel then remove inside door handle 10mm screw on the inside edge of handle.gently lift up on the door panel.now you have acess to the electrical connector and the three nuts that hold on the mirror
Most cars your will have to remove a small trim panel on the inside of the door directly behind the mirror. If it is power there will be a harness connector coming from mirror. disconnect the connector, then there will be (3) nuts holding the mirror to the door. remove the (3) nuts. That's it, to install reverse above order.
remove inside pannel you will see 3 nuts behind mirror remove and mirror will come out install new
To replace the passenger side mirror on a Chrysler Voyager you need to first remove the window trim. Next, disconnect the wires and unscrew the mirror from the door. Reverse directions to replace with new mirror.
it is in driver mirror
romove inside door panel, unfasten old,replace,plug in refasten new,replace doorpanel.
Removal and Installation Remove the trim panel. Release the clip. Release the locating tabs. Remove the trim panel. Disconnect the exterior mirror control switch electrical connector. Disconnect the exterior mirror electrical connector. Release the clip. Release the electrical connector. Disconnect the electrical connector. Remove the exterior mirror. Remove the bolt. If equipped, remove the screw. To install, reverse the removal procedure.
The passenger side mirror on a 2001 Toyota Sienna is mounted by screws. To replace the mirror remove the mounting screws and unplug the wire clip.