answersLogoWhite

0


Best Answer

i use to have the same year make and model secca. my suggestion would be a haynes service manual. it was like gold when it came to working on my bike. they cost about $20.00 and can probly be ordered at autozone or your local Yamaha dealership or parts and service center. goodluck

User Avatar

Wiki User

โˆ™ 2011-09-12 21:02:21
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the rear disc brake on a 1993 Yamaha Seca II XJ600?
Write your answer...
Submit
Related questions

What do you need to do if the rear brake caliper on a 1993 grand prix will turn but not compress?

Replace the caliper and bleed the brake system.


How do you change the front brake pads on a 1993 Ford Aerostar 4.0?

Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car to the ground.


Where is the clutch master cylinder located and how do you replace it in a Ford Escort LX 1993?

Shared with the brake fluid.


How do you replace the stop lamp sensor on a 1993 Volvo 940?

check the switch on the top of the brake pedal.


How do you replace the brake lights on 1993 Lexus ES300?

1992 Lexus es300 wear the thermostat is located


How do you replace brake pads on a 1993 Chevy sport van?

Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Properly dispose of the old pad, put in the new brake pad, replace the brake shoe/caliper, put the tire back on and lower the car.


Diagram for 1993 civic rear drum?

Diagrams for a 1993 Honda Civic brake system can be found the factory service repair manuals. These manuals will also explain in detail how to properly replace and repair the brake components.


How do you replace a master cylinder on a 1993 Toyota Pickup?

remove brake lines, remove bolts on the bracket that holds the cylinder to the brake booster then its free. Some cases you will have to pry open the brake shoes.


Can you replace the console of the 1993 wrangler with the 1998 wrangler?

You might have an issue with the 4wd shifter location, and the 93 has a foot brake instead of a hand brake, but it will probably go.


When was Yamaha Wave Blaster created?

Yamaha Wave Blaster was created in 1993.


Torque spec for 1993 Yamaha xj600s?

34ftlb is the torque for 1993 Yamaha xj600s. I am giving the linkthat will increase the knowledge about bikes.


How do you turn off the brake light for a 1993 Nissan pickup truck?

check and see when your brake pedal is not pushed down if it is pushing the brake swith pin back in if so you need to replace the brake light swithch located behind the pedal


Your 1993 town car wont shift?

do your brake lights work? there is a brake on/off switch attached to the brake pedal that also puts power to the shifter solenoid, this wiring tends to burn out, the switch is about $ 15 to replace.


How to replace the brake light bulb in a 1993 dodge stealth?

The brake lights and all of the rear lights can be access through the inside back molding in the rear. there are little knobs that you turn to access them.


What is the engine size on a 1993 Yamaha waverunner wr500?

The engine size is Yamaha WR500 in a 1993 waverunner, the engine size is right in the name of the jet ski.


How do you replace the brake pads on a 1993 dodge spirit?

Raise Vehicle, Remove Tire, take out the 2 Brake Caliper retaining bolts and remove caliper, take the old pads out and replace with the new ones... its as simple as that


How I release my the frozen brake cable on my 1993 Nissan Pickup truck from being frozen halfway?

Cut it off and replace it with a new one.


I have the number 4ew for a Yamaha motor what is the year?

it is 1993


How do you replace brake pads on a 1993 Jeep Cherokee Sport?

Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Next put in the new brake pads, put the brake shoe/caliper in its place, put the tire back on the car and lower the car.


Diagram of brake lines on 1993 topaz?

need diagram of rear brake lines for 1993 mercury topaz


Brake fluid 1993 mercury cougar?

A 1993 Mercury Cougar takes ( DOT 3 brake fliud )


How do you replace rear brake hose on 1993 jeep wrangler?

The hose goes from the diff to the frame, remove the two brake lines from the block on the diff, remove the mounting bolt, then disconnect the hose from the brake line at the frame. Install then bleed the brakes.


What is fuel tank capacity for a 1993 Yamaha virago 1100?

The fuel tank capacity of the 1993 Yamaha XV Virago 1100 is 4.7 gallons. This is equivalent to 18 Liters.


How do you remove rear brake drum from a 1993 Toyota pickup?

How do you remove rear brake drum from a 1993 Toyota pickup?


Where is the fuse box located in a 1993 Nissan 300z?

Where is the fuse locations? Interior and brake lights have gone out while attempting to replace fog lights.