On top of the cam cover is a removable plate. On some models it has VVTI 24V. It runs down the center of the cam cover. Underneath, after removal, will be 6 individual coils. Remove one coil to gain access to each individual spark plug. Do it one at a time to lessen the chance of dropping anything in the narrow sections.
Disconnect the battery, remove the spark plug cables, and spark plug boots. Remove the old spark plugs and replace with the new spark plugs. Replace the spark plug cables and connect the battery.
they did make a sunbird in 1998!
the answer is elsewhere on this site. it appears that 3 of the plugs are on the back of the engine and you have to jack up the car to get to them....
pull the old spark plugs out and put the new ones in dumbazz pull the old spark plugs out and put the new ones in dumbazz
find the plugs that connect to the plugs and pull them off.after that you can remove the plugs.
Disconnect the battery, remove the spark plug cable and covers, and remove the old spark plugs. Put in the new plugs, put back the covers and cables, and reconnect the battery.
If you dont know how to replace spark plugs I recomend you go to someone that does and have him show you because you might do more bad then good trying to change them for the first time.
It has spark plugs. They are just hidden from view.
you have to life up the rubber covering inside the wheel wells and the plugs are right there
Pull off the upper intake plenum and you will have access to the plugs and wires.
I suggest taking it to a garage as it has an alumnium head and sometimes the plugs seize and are hard to get out,
Replace the spark plugs,spark plug wires, fuel filter, oil, and oil filter. Mr.brown
Changing spark plugs is an important task. To do this, disconnect the battery and spark plug cables, and remove the old spark plugs. Next put in the new spark plugs, and reconnect the spark plug cables and then the battery.
HTE SPARK PLUGS ARE IN THE TOP OF THE ENGINE JUST IN THE MIDDLE
how u change spark plugs on 1998 gmc safari van
Disconnect the battery, remove the cables and boot covers, and remove the old spark plugs. Next, properly dispose of the spark plug, put in the new spark plug, attach the boot cover and wires, and connect the battery.
It has spark plugs, plug wires, and a distributor.
The 98 Tracer has four plugs
If you gap all the new plugs first and then replace the plugs and wires one at a time you won't have to worry about messing up the firing order. (This will happen if you pull all the plug wires at once and don't replace them in the same locations.)
You will need a general screwdriver, a spark plug socket, a socket wrench and and extender, a wire brush and a silicone dielectric compound. You should find more of these tools at SEARS or your favorite car parts dealer. You will need a spark plug wrench with an extension to replace the spark plugs in a 1998 Nissan Sentra. You can find an instructional video at www.youtube.com.
The spark plugs on a 1998 Mercedes Benz E320 are changed by removing the cover plate, disconnecting the plug wires, and unscrewing the spark plugs using a deep wall socket. New plugs are then put in place and torque down to specifications.
it's a 4 cylinder car, right? so it should have 4 spark plugs.
Screwed into the heads.
Screwed into the heads.