The speedometer is driven by the vehicle speed sensor. See "Related Questions" below for more about where to find it, and how to replace one.
Trans output speed sensor.
There is no speedometer cable. MPH is calibrated using a speed sensor. If your speedometer is not working, you have a bad speed sensor module.
the output speed sensor is the one on the transmission for the PCM and speedometer..it has a cable and a set of wires coming off of it..i think it is on the right side of the tranny near the output shaft
how do i replace front wheel bearinbs on 2000 ford ranger 4wd
there is no wire it is controlled by a sensor.
What is a carbon dioxide sensor?
The speedometer is part of the instrument cluster, and is fused with the other instruments.
There are either two or three wires on a water temperature sensor for a 2000 Ford Ranger 4.0.
The speedometer signal on a 2000 Ram comes from the ABS sensor on top of the rear axle.
If you don't have a speedo cable on your front wheel, you have a speedo sensor. I believe that change was made in 2000.
how to replace a knock sensor on a 2000 Chevy 6.0 step by step
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
Yes. The rear axle sensor feeds the ABS computer which feeds the cluster and the speedometer.
The VSS (Vehicle Speed Sensor) is located on the transmission. If the speedometer is not working, it is rarely the VSS causing the problem. I would first check fuses and the ECU
how do you replace ambient light sensor on 2002 silverado
how to change speedometer sensor on mazda millenia 2000 2.3 v6
A 2000 Dodge Neon does not have a maf sensor.
Were is location speed sensor
I just replace the abs speed sensor on my 2000 ford range for the same problem. It's located on the rear differial axle on top. cost approx. $23.00 for the sensor. 10 minutes to replace with the approiate socket. Nothing special.
If the speedometer/odometer is working, chances are the VSS (Vehicle Speed Sensor) is good.
Also known as the vehicle speed sensor. It is located on the top of the transaxle just behind the starter. It can be checked by removing the sensor. Then, using a multimeter, spin the gear and watch for a pulsing AC voltage signal.
The oxygen sensor on a 2000 Silhouette is mounted to the exhaust system. To replace it raise the vehicle and safely secure it. Make sure the engine is cold. The sensor is thread in to the exhaust pipe. Loosen the sensor and unplug it. Replace the sensor.
on top, right side of trans