First, disconnect the negative cable on the battery. Remove bolts support the starter. Lower and tilt starter to give you access to the wires. Detach the wires. Install starter in the opposite method of removing.
how to replace starter 1993 88hp Johnson outboard
Make sure the solonoid is bad first.. It is on top of the starter and the starter has to be removed to replace it.
bolt pattern for 1993 toyota celica starter
If your speaking of the starter solenoid, it is mounted directly to the starter. The starter would have to be removed in order to replace the solenoid.
you have to remove the starter to replace the relay and the relay cost almost as much as the whole starter so you are better off just replacing the whole starter.
It is mounted on the starter motor itself. When you get another starter, it will have the solenoid mounted on it already. If it is bad, just replace the starter, I would not change just the solenoid.
follow the wires that come off the positive battery terminal the starter has two bolts to take off then the starter comes off then unhook the power wires from starter
Remove the positive cable from your 1993 Mercury battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
Replace it with a new one, there is no repairing it.
its under the intake manifold if its a northstar
must lower the exhaust system
on a 2002 4 wh drive Blazer - disconnect the battery - lossen starter bolts ( 2 ) loosen and remove the Flywheel plate that the Starter is inserted into or you wont be able to pull the starter out - really tight space 2 bolts to remove this plate - plate has an opening that the starter goes into to engage the flywheel