Here ya go:
http://nissannut.com/projects/Poly_bushings/
Please see attached link. Good Luck http://www.mp3car.com/vbulletin/worklogs/80285-2001-pathfinder-carputer-my-first-install.html
link pins. bushings and links Stabilizer link bushings.
get under vehicle with out jacking vehicle off the ground hold sway bar with hands try to move bar sideways if bar slides sideways in bushings, the bushings are shot not a hard job to repair
fog light not working and radio light went out
To replace the front sway bar link bushings and mounts on a 1986 Jaguar XJ6, first lift the vehicle and secure it on jack stands for safety. Remove the wheels to access the sway bar links, then use a socket wrench to detach the sway bar link bolts from the sway bar and the control arm. Replace the old bushings with new ones, ensuring they are properly seated, and reattach the sway bar links, tightening the bolts to the manufacturer's specifications. Finally, reassemble the wheels and lower the vehicle.
Front sway bar link bushings. Cost under $50, took about an hour to replace both sides.
Check out this website for details on how to find and replace the fuel filter on a 2003 Nissan Maxima.Visit the Related Link below for more on this.
change the sway bar rubber bushings and sway bar link bushings
Im about to find out! Both left and right bushings are missing. so I have decided to just replace the pins and all. It doesn't look all that bad though. I will update when it is complete!
take the acr to the body shop. It is a cheap fix and they have the expertise.
The "cluster refers to the whole guage assembly...ie, the speedometer, tachometer, fuel and temp guages and whatever else yours has. The voltage regulator you're looking for is behind the guages on the back right hand side. Here's a link to a webpage showing how to replace it. http://www.nissanpathfinders.com/Solution2.pdf
They just unbolt at both ends. I have never seen an actual sway bar break, usually just one of the linkages. You can buy a link kit for about $10. It has the bolt, bushings and caps you will need to replace one end.