Mercury Topaz
Thermostats
Mercury Tracer

How do you replace the thermostat located on a Mercury Topaz?

616263

Top Answer
User Avatar
Wiki User
2007-01-03 02:58:29
2007-01-03 02:58:29

Assuming it is a four cylinder 2.3Litre It's realitivlymeast A 10mm ratchet wrench and a 10mm socket and handle Remove air filter cover loosen 2(two) 10mm bolts in housing attached to upper rad hose Pry housing from block scrape old gasket materialfrom both surfaces Pry out old t-stat work in reverse order to reassemble. "bobs my uncle"

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

follow the upper radiator hose to the thermostat housing

User Avatar

Follow top rad. hose. It's in that housing.

User Avatar

Just follow the top rad hose. It's in the housing.

User Avatar

the thermostat is underneath the manifold, follow the top radiator hose and unbolt the manifold. fairly simple.

User Avatar

I need to find out how to replace a fuel pump for a 1993 Mercury Topaz, 4 cylinder, fuel injection

User Avatar

picture on how to replace a water pump for mercury topaz

User Avatar

If you fallow the rad hose off the top of rad there will be a body that the hose is clamped on to at the motor it will be under there

User Avatar

On the top drivers side of the engine where the upper radiator hose connects. The thermostat is in the same assembly that the Fan sensor screws into and is removed by taking out 2 bolts.

User Avatar

The coolant temperature sensor on a 1993 Mercury Topaz is located at the rear of the engine. To get to it, you have to remove the driver side fan.

User Avatar

Find it in the fuel line. I don't think it requires any special tools.

User Avatar

IF anyone has any imfo on how best to replace an ignition system on a 1993 Mercury topaz please call 714-6383162, or e-mail me at KN657@yahoo.com

User Avatar

Located in a removable housing at the engine end of the upper radiator hose

User Avatar

Mercury Topaz was created in 1983.

User Avatar

The fuse block should be located to the left of the steering column, under the dash. Depending on which Mercury GS you have (sable, topaz, etc.) it should be a relay located in the fuse block.

User Avatar

Look at your radiator. Find the upper hose. Follow it towards the engine. At the end will be your thermostat housing. Guess whats inside?

User Avatar

Is there power to the pump??? If YES, replace the pump. If NO, replace the fuse.

User Avatar

Sorry , no ansewer because no Topaz 1995 ; last production was 1994.

User Avatar

Not quite sure what you are looking for?

User Avatar

Horn's should be in the fender wells in the engine compartment.

User Avatar

They should be in the front fender well, in the engine compartment.

User Avatar

Have to take off the head, it's there.

User Avatar

Follow the Upper Hose toward the motor and when it ends, that's the housing.

User Avatar

it should be located right below the oil filter in the front


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.