Where is the thermostat located and how do you replace it on 1992 toyota camry 4 cylinder ingine
To replace a thermostat on a 1992 Geo Storm first locate the its housing. Once found drain the coolant system and remove the housing from the engine. Replace the thermostat.
Drain the water from the cooling system of your 1992 Saturn. Remove the water hose. Remove the thermostat housing retaining bolts. Take the thermostat out. Reverse the process to install the new thermostat.
I found the answer at http://autorepair.about.com/library/faqs/b1103f.htm
Bel Tempo ended in 1992.
Installing a thermostat on a 1992 Chevrolet Corsica is very easy to do. First, follow the upper radiator hose to the thermostat. Then, you will disconnect the hose and drain it. After the hose is drained, take off the two bolts holding the thermostat housing in place. After the bolts are removed, take the old thermostat out and replace it with a new one.
what kind of fule pump is in a 1992 ford tempo
1992 Lexus es300 wear the thermostat is located
Thermostat stuck open or a clogged heater core. Service and flush the cooling system and replace the thermostat.
Follow the lower radiator hose from the radatoro to the engine. The lower hose is attached to the thermostat at the engine. Are you haveing problems with the engine warming up but the heat not blowing as hot as it should? Consider the heater core.
fuse panel diagrame for 1992 ford tempo fuse box
where is the thermostat located in a 1992 cutless supreme automobile
special tools are required to do this job.slide hammers impact tools.yhis is not a job for diy!!
The thermostat in a 1992 Honda Accord is found in the thermostat housing. The thermostat housing can be found by following the lower radiator hose.
follow radiator hose unscrew the to bolts and it will be inside
it is in front of the engine block under the water pump kinda low on the engine
you can get the answer here! i answered it last night for some one else!
what is the cost to fix an overheating Subaru Legacy Wagon. Is it the thermostat? How much are they to replace?
need a diagram and instructions on changing a water pump on a 1992 ford tempo 4 cylinder
follow the upper radiator hose from the radiator to the engine this is where youwill find the thermostat housing. remove ther housing and you'll be looking at the thermostat. it is realy easy
Il tempo della semina was created in 1992.
The thermostat is located at the end of the 2" radiator hose that leads into the engine block. The housing doesn't look like the traditional round ball. Also, there is a "sensor" that plugs into the housing. Hope this helps.
The thermostat is located under the thermostat housing which is connected to the engine side of the upper radiator hose, and bolts to the intake manifold with 2 bolts. To replace, drain and properly dispose of coolant, remove upper radiator hose, and remove thermostat housing. The thermostat sits in a recess between housing and manifold. Replace with correct thermostat with the correct side facing engine, new gasket and a little sealant.
The thermostat, on your 1992 Mazda, can be found on the front bottom portion of the engine. You can follow the water hose from the bottom of the radiator to the thermostat.