HomeHow do you replace the water pump on a 1988 Jeep Cherokee?
Wiki User
2011-09-12 21:05:52
2011-09-12 21:05:52
1. Diconnect the negative battery cable 2.Drain the cooling system 3.disconnect the hoses at the pump 4.remove the drive belts 5.remove the power steering pump bracket. 6.remove the shroud and fan 7.unbolt and remove the pump. TO INSTALL 9.clean the mating surfaces thoroughly 10.using a new gasket, install the pump and tighten bolts to 13 ft. lbs. 11.reinstall all componets in reverse order. 12.after complete operate the engine with heater control valve in heat position until the thermostat opens to purge any air in system check coolant level and fill as required.
Related Questions
How do I replace water pump on 2004 jeep grand Cherokee
my jeep Cherokee 1998 4.0 is a straight 6
An AW4 transmission from a 1991 Jeep Cherokee will not fit into a 1988 Jeep Cherokee. The transmissions in the varying years do not appear to be compatible with one another.
A 1988 Jeep Cherokee has one oxygen sensor.
The transmission oil line from a 1991 model of a Jeep Cherokee will fit a 1988 model of a Jeep Cherokee because the transmission oil line fits all Cherokee models that were made between 1987 and 1996.
Where is the fuel pump located on a 1985 jeep cherokee
Labor cost lifter for jeep cherokee
How to replace spark plugs in a 1989 jeep cherokee?
Jeep grand Cherokees are normally more $ than regular Cherokees, the grand Cherokee was originally made to replace the Cherokee
Probably not. What you will do is remove the fan first, and then the fan shroud. The reason for removing the shroud is so you have more room to work.
Driver side of firewall.
AROUND 150 TO 200.00. NOT THAT EASY TO DO.
The 1988 Jeep Cherokee fuel pump relay switch is located on the firewall in the engine compartment. The switch will be on the drivers side of the firewall.
The transmission will have to be removed.
Replace the ignition coil.
there really is no difference in the engine it will be the computer and electrical connections
A 1988 Jeep Cherokee does not have an inertia switch. The fuel system is computer controlled with relays.
Yes, but you will need to use the parts off the vehicle you are putting the engine into.
The Jeep Grand Cherokee didn't exist until 1993.
No. Too many differences between those years.
Yes, only if they have the same engine.
no. 1986 to 1990 sorry
No, the 1988 uses a AW4 trans. The 1996 Grand uses a 42re trans.
It will cost you approximately $300 to replace the rear main seal on a Jeep Cherokee. The amount will vary slightly depending upon who does the work for you.
Some parts will, some parts will not. If you ask New questions about specific parts, you will get specific answers.
What are the advantages of stress interview?
Why the story entitled origin of fair complexion and fair hair?
Ano ang kahulugan ng iskolarling pagpapahayag?
What is a classified data spill or negligent discharge of classified information?
Ano ang papel na ginagampanan ng mga impormasyong ito sa mapa o sa globo?
Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.