Water Pumps
Dodge Durango
Toyota Tercel

How do you replace the water pump on a 1988 Toyota Tercel?

565758

Top Answer
User Avatar
Wiki User
2006-04-18 21:39:00
2006-04-18 21:39:00

did my '85: drain fluid remove 2 belts loosen the alternator mount for one (2 bolts) remove the tension pully on the other (2 bolts) remove water pump pully (3 bolts) remove upper timing belt cover (5 i think) remove water pump (7 bolts) attach everything back in reverse order be careful not to drip fluid into the oil tube or the hole when you remove the dipstick mount

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The timing setting for a 1988 Toyota Tercel is the "3E" hole lines at the top. This setting is for a Tercel EZ 1500 engine.

User Avatar

the voltage regulator is built into the alternator

User Avatar

You can find a 1988 Toyota carburetor diagram at most Toyota dealerships. The diagram can also be found in Toyota service manuals at your local library.

User Avatar

http://www.modifiedlife.com/1988-toyota-tercel-car-stereo-radio-wiring-diagram/ Change the year in the link to your Tercel's year

User Avatar

A quarter of a million miles if you treat her right

User Avatar

Get a manual on your car to do the job right. In short, you have to pull the timing belt covers and timing belt. Get a manual.

User Avatar

disconnect negative battery tml.,remove the plug from the alternator,remove the main battery wire from the stud on the alternator, remove the lock bolt, swing alternator down to remove belt, remove pivot bolt, swing alt. until its out. replacement is reverse of remova; To take out the alternator on a 88' tercel, you have to do it from under the car

User Avatar

thermostat is located on engine block. follow top water hose leading to engine. thermostat is located inside the water intake. remove hose. remove water intake(two bolts)housing. replace thermostat. .

User Avatar

How do you replace the water pump on a 1988 Cadillac Seville?

User Avatar

I just want to know when do i have to replace the water tank.

User Avatar

Look in the owner's manual or in a repair manual. If you don't have them, buy both. You'll be glad you did.

User Avatar

Call up a locksmith and have a talk with him will direct you in the right direction.

User Avatar

I'm dealing with the same problem on my station wagon Camry 1989. Pep boys say have to order thru Dealer

User Avatar

fuel pump is manual and sitting on top of engine,by the distribitor.behind the valve cover.(Can be traced from fuel filter near lower part of brake boster.)

User Avatar

I have one available, in good condition, I do not need it any moore...email me @ mr_tihera....yahoo. if you need it.

User Avatar

Change a starter on a 1988 Toyota Cressida

User Avatar

In order to replace the water pump on a 1988 Toyota Camry v4, first remove the front timing belt cover as well as the motor mount on the passenger's side of the vehicle. In order to remove the mount, the engine must be supported. Before removing the timing belt, mark the camshaft and crankshaft for guidance during replacement. Remove the water pump, and apply new gaskets to the new water pump with a sealant. Install the new pump, then the hardware that had been removed in order to access the pump.

User Avatar

how to do ignition timing on 1988 Toyota corolla fx

User Avatar

How do you change a fuel injector on a 1988 Toyota Camry

User Avatar

oil can come from about any were, it could be coming from the rear main or the front you can ha gasket that you need to replace.

User Avatar

Who says it has a kill switch? I have workshop manual and did not see one! Have had trouble with auto shifter stick in park..had to short out "kill " switch, to prevent starting when not in park.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.