Water Pumps
Dodge Durango
Nissan Sentra

How do you replace the water pump on a 1994 Nissan Sentra?

104105106

Top Answer
User Avatar
Wiki User
2015-07-16 18:23:27
2015-07-16 18:23:27

Not sure on a '94, but on a '90 w/ a 1.6 you just remove the pulley bolts on the water pump, take off the pulley and belt, remove the thermostat housing on the side of the water pump, and then remove the water pump bolts. After that you can take off the water pump.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Were is the timing mark an a 1994 Nissan sentra 1.6l?

User Avatar

How do yu adjust idle in a nissan sentra

User Avatar

To replace the headlight bulb in a 1994 Nissan Sentra first prop the hood of the car. Locate the headlights and remove the bulbs from the housing. Install the new bulbs.

User Avatar

1994 Nissan santra firing order

User Avatar

how do you remove a distributor rotor on a 92 Nissan sentra

User Avatar

how do you change the ignition key switch on a 1994 nissian sentra se

User Avatar

yes the trans is the same in all 91-94 for the 1.6L motor

User Avatar

4 bolts at the filler and the other you have to put your head under the car and look

User Avatar

Yes, but with improvements along the way. Better camshafts etc...

User Avatar

no because the maxima is a 5 lug and the sentra is 4 lug

User Avatar

To find the ignition key code for a 1994 Nissan Sentra SE, check the owner's manual. You can also contact the manufacturer to obtain the code.

User Avatar

replace your pressure plate (diaphragm type), and the clutch. replace your pressure plate (diaphragm type), and the clutch.

User Avatar

Try website, Nissan performanced magazine.com, and their affiliates; sentra.net.

User Avatar

I have a 1994 Sentra, and the relay is inside the steering wheel assembly, soldered onto a circuit board.

User Avatar

The diagram, for a fuse panel, on your 1994 Nissan, can be found on the inside of the fuse panel cover. A diagram can also be obtained from most Nissan dealerships.

User Avatar

the fan clutch is built into the water pump,it cant be separated,you have to replace the water pump.

User Avatar

BeltsYes, you must remove all of the belts to replace the alternator belt. The compressor belt first, then the power steering belt then the alternator belt.

User Avatar

i believe the openings are around 6 3/4"


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.