0
I am an Infiniti service advisor. The water pump is driven by the timing belt. Perform a full timing belt service with new drive-belts, thermostat, water pump, timing belt, and ENSURE you replace the camshaft seals and crankshaft seal. There are quite common to leak. I would recommend visiting your local dealership as this service is quite extensive. Also, be prepared for a crankshaft pulley replacement, which you have to remove anyhow to do the timing belt/water pump. The pully itself is around $250. The other parts run $200-400 and labor is 9.0 hours with everything I mentioned. If you've had your timing belt replaced in the past, recommended service interval is 105,000 miles, all these parts I mentioned should have been replaced. Especially the cam and crank seals. If you're unsure, check your repair invoice from where you had the work performed.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How do you install 1994 infinity 2.0 crankshaft and water pump belts?
how to replace a water pump for a infiniti g20
How to replace a water pump on a 1997 Honda Accord?
where is the water pump located on 1997 honda accord
How do you replace a 1997 Nissan Pathfiner v6 water pump?
if i replace the water pump i have to do the timing bell
How do you install a water pump in a 1997 Oldsmobile aurora?
remove and replace water pump in 1997 Oldsmobile aurora
How much to replace a water pump for 92 infiniti q45?
is included with timing belt service
How hard and detailed is it to replace water pump on dohc 1997 dodge neon?
Water pump
What is the average cost to replace the water pump on a 1997 Chevy Blazer?
The average cost to replace your 1997 Chevrolet Blazer water pump is $230. The water pump will cost approximately $80 and require two hours of labor.
How do you replace the water pump on a 1997 Plymouth Breeze?
You must remove the timing belt to get to water pump.
Locate the water pump by diagram on 1996 infiniti I30?
need help changin water pump on a 1996 infiniti i30
How do you replace the water pump on an Infiniti G35 2003?
i wouldn't make a attempted if your asking this question just take it to a shop
How do you replace the water pump on a 1997 Plymouth Voyager 3.0L?
water pump on this 3.0 is driven with the timing belt. it is internal water pump you will have to set your timing before you start replace your timing belt if it is worn out.
How do you replace water pump on a 1997 mercury villager?
You will need to drain the water from your 1997 Mercury Villager cooling system. Remove the water pump belt. Remove the water pump hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
