Drain coolant. loosen water pump pulley bolts and remove serpentine belt. ON V6 ENGINES, unbolt and move thhe Power Steering pump bracket
*You will need to remove the bottom coil, or in some cases, all three coils, including the tray they sit on in order to reach the top bolt of the power steering pump bracket. You should number or tag each coil and wire at this time to prevent a mixup during installation.*
remove hoses from the pump. remove water pump pulley and unbolt the pump.It may be necessary to tap the pump with a soft face hammer to break the gasket seal. ON V8 ENGINES. remove the fan. remove all hoses from the water pump.disconnect the coolant temp sensor from the pum and unclip the wire harness from the 2 clips on the faceplate of the water pump.unbolt the ign coil bracket and move it out of the way. unbolt the air pump which is below the coil.remove 2 bolts that hold the air pump bracket and move it over.remove the 6 bolts holding the pump to the block. If neccessary, tap with soft face hammer to break gasket seal. INSTALLATION.clean the gasket contact surfaces. place gasket sealer on the new gasket an place it on the pump. on V8s you should replace the o ring on the spline at the engine block end and dont force the new pump over them. .place pump in position and finger tighten bolts in place, careful to not move the pump gaskets. replace any brakets that were removed. the rest is just the reversal of removal. Add coolant and check for leaks.
in the gas tank. you have to remove the tank to replace the pump.
You have to pull the serp. belt, coil packs, power steering pump pulley, power steering pump mounting bracket, and then you can get the water pump out.
you have to remove the air intake and its right under there..but of course its deepset...no room to work on those big of motors in a camaro lol.....i got a 94 z28
On the side of the water pump housing
If you are referring to the water inlet hose on the back of the water pump you can use this question as reference. How do i replace the water pump on a 1993 Geo Prizm 1.8L?
Yes, it does.
In the gas tank.
The water pump on a 94 Saturn S1 is replaced by removing the serpentine belt, engine accessories, and water hoses. The pump can then be unbolted from the engine block and a new pump put in place.
How do I replace the water pump in my 1994 Saturn SL2 series standard twin cam.
The water pump is timing belt driven you got to get to the timing belt to have access.
What about the timming
you uhh buy a new one