answersLogoWhite

0


Best Answer

You may reset the code by pressing either the unlock or lock buttons on the remote control. Within 1 minute of doing this, insert the key into the driver door and turn the key to the lock or unlock position.

User Avatar

Wiki User

โˆ™ 2006-07-08 22:34:35
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reprogram the key less entry fobs on a 2002 A4?
Write your answer...
Submit
Related questions

What is the cost to reprogram key less entry for your mercury mountaineer?

This is up to the dealer doing the job, count on $100 US


Where is a key less entry pad in a 2002 Escalade?

There are two entry pads on the 2002 Escalade. The first is the remote pad and second is located in the secondary information center on the dashboard.


How do you program a key less remote for a 2004 Tiburon GT?

As much as you don't want to hear this, the only way to program a key less entry remote for a 2004 tibby is to take both key fobs and the car to the dealer. Don't shoot the messenger.


How do you reprogram the key-less entry remote for a 2004 RX8?

I've been working in the automotive feild for over 10 yrs. now and to my knowledge the only people who can reprogram the key-less entry remote,are the dealerships,most repair shops have all-data or mitchell on demand.....you could go on-line and pay for that information,however I'm not sure if all-data or mitchell would even have that info. Dealerships love keeping certain information for themselves so they can reach into your pockets. Good luck


Does your 2002 dodge ram 1500 have keyless entry?

If you call your local dealer with the VIN they can tell if it was built with key less remotes.


Where is the key-less entry key pad code for a 2005 Lincoln Continental located?

Ford stoped makeing Lincoln Continental's in 2002.


How do you change batteries in a 2002 Mercedes ML500 key-less entry?

the batteries are in the keyless go key .the owners manual shows you how 2 do it


How do you retrieve key less entry code for mercury marquis?

retrieve key less entry code for mercury marquis


How do I reprogram remote for a 2002 Ford Explorer?

if i remember right, you have to turn the key on and off eight times in less than ten seconds. then you push every buttom on the remote and turn ignition off. pretty sure but no guarantees


Where to find the key less entry code on a 2001 Ford Expedition?

Where do I find the key less entry code on a 2001 Ford Expedition?


How do you program a key less entry remote for Toyota Camry 2011?

You have to have the dealership program a key less entry remote for 2011 Toyota Camry.


What is the factory code for the key less entry on a 2001 ford expedition?

Each 2001 Ford Expedition with key less entry has it's own factory code


Can 1 key less remote work on 2 different cars Cars are a 1995 corvette hard top 2008 GP?

You will not get one remote to work for both of those cars. If you had two cars that use the same style of keyless entry remotes(also called Key FOBs) you could program the two cars to use the same remote.


Does the 98 Volvo S70 come with key-less entry or is there a way to get the passenger door to lock?

yes, it originally had keyless entry. You can find used key fobs on Ebay, 2 types, panic and no panic button. You will need to get tehm programmed at the dealer. If they are cool they will only charge you for 1/2 hr labor. If your passengers door does not lock you most likely need a door lock actuator. Mine won't unlock... lazy... They cost about $115


How do you program a 2002 Lincoln ls wireless key fob?

1) Gather all key fobs you want to program to your car. (I suggest buying used fobs from a salvage yard. Ford charges around $40-80 for a new one; a scam many people fall for. Most any similar-looking Ford/Lincoln/Mercury/Mazda fob will work. Maximum 4 fobs per vehicle.) 2) Get in the car, and insert the key. 3) In 10 seconds or less, rotate the key back and forth from Off to On eight times, leaving the key On the eighth turn. The doors will lock and unlock to signal Programming Mode. 4) Press a button; any button, on the fob. The doors will again lock and unlock to signal that the fob has been programmed successfully. Do this for each fob in 20 seconds or less. 5) Turn the key Off. The doors will again lock and unlock to signal that Programming Mode has been turned off. Now test each fob to ensure it works. If any fobs do not work, you will have to repeat the process for *all* fobs.


Is power lock and key less entry same?

Not necessarily. Keyless entry will have power door locks, but not all power door locks are coupled to a keyless entry system.


How do you reprogram a 1999 Chevy Tahoe key?

If you mean the key less entry you simply need to take a paperclip and insert it in the #4 and #8 prongs on the diagnostic box located under the steering wheel, it will cycle the locks then just hold down the lock and unlock on the remote for 30 seconds and the test. Mr. Moose


What are the ratings and certificates for The Look for Less - 2002?

The Look for Less - 2002 is rated/received certificates of: Australia:PG


How do you know if your 2006 Kia Sportage has keyless entry?

Because if the KIA sportage has power locks it has or can get a key less entry system


How do you remove a 2000 ford expedition xlts key-less entry system?

You need to refer to the service manual to remove a 2000 Ford expedition XLTS key-less entry system.


Where is the key-less entry code for a 2002 Lincoln Navigator?

I called Ford. They instructed my to look up the steering column from the pedal area, for a sticker with the five digit code. It is a bit difficult to get to but it was clearly visible.


How do you program key less entry for 1998 GM jimmy?

you have to take it to the dealer.


How do you program key fob for a 2000 Lincoln ls?

1) Gather all key fobs you want to program to your car. (I suggest buying used fobs from a salvage yard. Ford charges around $40-80 for a new one; a scam many people fall for. Most any similar-looking Ford/Lincoln/Mercury/Mazda fob will work. Maximum 4 fobs per vehicle.) 2) Get in the car, and insert the key. 3) In 10 seconds or less, rotate the key back and forth from Off to On eight times, leaving the key On the eighth turn. The doors will lock and unlock to signal Programming Mode. 4) Press a button; any button, on the fob. The doors will again lock and unlock to signal that the fob has been programmed successfully. Do this for each fob in 20 seconds or less. 5) Turn the key Off. The doors will again lock and unlock to signal that Programming Mode has been turned off. Now test each fob to ensure it works. If any fobs do not work, you will have to repeat the process for *all* fobs.


How do you program the key fob on a Lincoln continental?

1) Gather all key fobs you want to program to your car. (I suggest buying used fobs from a salvage yard. Ford charges around $40-80 for a new one; a scam many people fall for. Most any similar-looking Ford/Lincoln/Mercury/Mazda fob will work. Maximum 4 fobs per vehicle.) 2) Get in the car, and insert the key. 3) In 10 seconds or less, rotate the key back and forth from Off to On eight times, leaving the key On the eighth turn. The doors will lock and unlock to signal Programming Mode. 4) Press a button; any button, on the fob. The doors will again lock and unlock to signal that the fob has been programmed successfully. Do this for each fob in 20 seconds or less. 5) Turn the key Off. The doors will again lock and unlock to signal that Programming Mode has been turned off. Now test each fob to ensure it works. If any fobs do not work, you will have to repeat the process for *all* fobs.


How do you program key fob for a 2001 Lincoln ls?

1) Gather all key fobs you want to program to your car. (I suggest buying used fobs from a salvage yard. Ford charges around $40-80 for a new one; a scam many people fall for. Most any similar-looking Ford/Lincoln/Mercury/Mazda fob will work. Maximum 4 fobs per vehicle.) 2) Get in the car, and insert the key. 3) In 10 seconds or less, rotate the key back and forth from Off to On eight times, leaving the key On the eighth turn. The doors will lock and unlock to signal Programming Mode. 4) Press a button; any button, on the fob. The doors will again lock and unlock to signal that the fob has been programmed successfully. Do this for each fob in 20 seconds or less. 5) Turn the key Off. The doors will again lock and unlock to signal that Programming Mode has been turned off. Now test each fob to ensure it works. If any fobs do not work, you will have to repeat the process for *all* fobs.