Turn the key to the 'on' position (do not start the truck).
Wait for the change oil light to come on.
Tap the gas pedal 5 times.
Move key to off position, move key back to on position. The change oil light should be reset.
The engine light on a Chevy Colorado can be rest by connecting an OBD II reader to the interface port under the dash. Each code can then be reset which will disable the dash light until the error is detected again.
read your owners manual
reset engine light on 2005 Chevy Colorado 3.5 engine
The abs light is on because there is a problem with the abs system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself after a short drive.
You need to reset the change oil light. Simply turn ingnition key to the on position (do not crank engine) then depress gas pedal to the floor three times, wait a few seconds and the change oil light will flash 5 times. This completes the reset.
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
Turn on the key but don't start the engine. Push down and release the accelerator pedal 3 times. It will now reset.
Take it to a shop or take the batter out and let it reset itself then put the batter back in
How do I reset the service engine light on a 2003 Chevy Trailblazer?
The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.
How do you reset check engine light for the 2009 Chevy trail blazer?
When you take your car in for an oil change, have the technicians there do the reset for you. (they should automatically do that for you, but you may have to ask them....to make sure they do it) Valvoline does it as part of their service.