Turn the engine two seconds then leave the key in the run position for exactly ten minutes...the anti-theft security light should go from blinking to solid at the ten minute mark. Immediatly run the engine and the Passlock is reset. Good Luck!!
security to hamper theft. It prevents "smashing" the ignition cylinder to turn the steeering wheel
sensor is located in the ignition housing itself and can not be serviced seperatly from the housing, it must be replaced
odometer button
H
Repair the problem and it will typically reset itself after 3 starting cycles.
There are a myriad of possible "solutions" available. If you are even just a little bit technically savvy you can with a little bit of effort disable and or bypass the "passlock" system. Just Google Chevy impala passlock disablement or Chevy impala passlock bypass. There are several ways to do this and it would be better for you to read all the information available and arrive at your own decision. This seems to be a "VERY PREVELENT PROBLEM"
It is not equipped with an inertia switch.
how to use bcm to reset change oil light
wait 10 minutes for the passlock system to reset for a GM vehicle.
cut the yellow small wire from ign. switch in the column up by the switch. this is the passlock wire. but will it start iwas told that it wouldnt
how can I reset the security system on my 06 saturn vue
== == The repair below is a theft password relearn procedure. It may get your car to start for a while, but does not repair the problem. The most common cause for this problem is the PASSLOCK ignition cylinder. It may need to be replace, then re-learned again.- TechJK -------------------------------------- Turn the key to the on position for about 30mins. After the first 10 minutes the security light starts to blink. Then it turns solid again after another 10 minutes. The last 10 minutes is to reset the passlock system (you can leave it on for longer to make sure you reset it). Now take the key out and try to start the car. I had to do this when my car was not starting; the fuel pump was off because of my passlock system.