i know for the older models, you turn key forward, don't start. pump gas three times and than pump a fourth but hold the pedal to the floor for at least ten seconds
What is needed when the ccr is driver information center
If you have a driver information center (DIC), go to the settings and change your units from English to metric.
Press both buttons on the "driver information center" at the same time. That should reset it for you.
to reset the change oil message, hold the Eng-Data and Range buttons at the same time until you see the 100 on the drivers information center.
Its in your DIC (driver information center) center stack. You know, the menu personalization screen where the radio is? You change it in there unlike pushing a button near the speedometor like some/most automobiles.
It is correct,
There are several things that can cause your 1993 Jeep Grand Cherokee driver information Center not to work. The most common cause is a blown fuse.
the driver info button is on the dash tothe right of the steering wheel
Read the owner's manual, the procedures vary.
Press and hold the on/off button in the driver information center for 3 seconds. It will convert back to English. YES...it is that easy. I was just on hold for 30 minutes with Oldsmobile to get this question answered. The car should be running, in park. Press and hold on/off button of driver information center for 3 seconds. Do not confuse this with the power button for the radio. Good luck.
Silverado driver information centers may not be working properly if the systems are down. Sometimes the center may need their I.T department to work on improving their systems.
What dose trip a 3 mean on my Pontiac G5