Turn the key on but don't start the car, depress the gas pedal completely to the floor three times within 5 seconds, turn key off and then start car. If you were successful the light should flash 5 times then go out.
This should reset it, works for almost all newer GM's
This is how you reset the light if your vehicle does not have the steering wheel controls. If it does, you reset the light with the steering wheel controls.
key on engine off press accelerator pedal to the floor five times very rapidly should reset
That REQUIRES an ENGINE SCANNER to do that.
Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.
Turn the key to the on position but do not start press the gas pedal 3 times within 10 seconds and the oil change light will flash 3 times and go out. now it is reset
Disconnect the negative on the battery terminal for 15 seconds.
No there is not. Chevy did not use them on there trucks.
You use a scan tool after repairing the cause of the code that turned the light on.
Chevy does not have a reset button, Ford is the only one that used those.
Chevrolet does not use inertia/reset switches.
After you change the oil, turn the key to ACC or ON but do not start it. Then press the gas pedal 3 times within 5 seconds. The sensor will then reset itself. chiefy98clg at yahoo dot com
Chevrolet does not use inertia/reset swtiches.
Chevrolet does not use inertia or reset buttons.