These are the instructions out of the Honda Service Manual for 1996-2000 Civics:
1.) Make sure the ignition switch is OFF.
2.) Connect the SCS service connector to the MES connector. Do not use a jumper wire.
3.) Turn the ignition switch ON.
4.) The SRS indicator light comes on for about six second and goes off. Remove the SCS service connector from the MES connector within 4 seconds after the SRS indicator light went off.
5.) The SRS indicator light comes on again. Reconnect the SCS service connector to the MES connector within 4 seconds after the SRS indicator light comes on.
6.) The SRS indicator light goes off. Remove the SCS service connector from the MES connector within 4 seconds.
7.) The SRS indicator light indicates that the memory is erased by blinking two times.
8.) Turn the ignition swith OFF, and wait for ten seconds.
Ok first you're asking what the SCS service connector is. Basically it's a jumper wire. It just has a connector so you can easily connect and disconnect it. You can in fact you a jumper wire. It just might make it a little more difficult. Now you want to know where there MES connector is. It's a yellow 2 wire connector located underneath the dashboard near the fuse panel.
How i reset the computer on Honda civic ex 2.000
yes
change the fuse
It depends on the model. D16Y8 Honda Civic EX 1996-2000 D15Z Honda Civic HF 1996-2000 D15Y7 Honda Civic DX/LX/CX 1996-2000
yes
No
No it will not.
yes
No. The motors are different, the 2000 Honda Civic uses D16 motors and the 2001 Honda Civics use D16 Motors.
Where is the main relay in a 2000 honda civic ex
go to auto zone they will run the machine that tells you why the light is on and they can reset it with that
2000 Honda Civic EX 0-60 in 8.5 secs.2000 Honda Civic Si 0-60 in 7.5 secs