answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you set the keyless remote on a 2000 Corvette?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you program factory keyless remote for 2003 hummer?

as far as I know you have to have the dealership do it cause they have to read the codes in the computer to set the remote


How do you set wing mirrors on 97 grand Cherokee limiyed it has a keyless remote and 1-2-set buttons on inside door?

Try the mirror control.


Where is the computer module for the keyless entry located in a 1999 Ford Taurus?

Look to the right of the steering column under the dash. I think the remote keyless entry is here & not sure if it's different from keyless entry.I'm not exactly sure if the computer that controls the keyless entry is what they're looking for - OR - the location of the factory set code for that vehicle.See "Related Questions" below for the location of the code


How do you program the remote keyless entry for a 1997 Ford Thunderbird?

1. Turn ignition to RUN or ACC. 2. Momentarily jump pins in programming connector located in LR quarter panel area (Connector will not be plugged into anything, it will have two pins inside it, if you have to unlug it you have the WRONG one. Not all vehicles are set up from factory for keyless remotes) All doors will lock then unlock to confirm programming mode. 3. Press any button on first keyless remote. Door locks will cycle to confirm programming. 4. If programming a second keyless remote, press any button on second keyless remote. Door locks will cycle to confirm programming. 5. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.


Does a 2000 Corvette have an inertia switch that would be set if the car was in a bad crash?

contact a local Chevrolet dealr they will be able to confirm that


How to set up keyless entry for 2000 Mitsubishi montero sport?

There are many products that provide a keyless entry system for any car with power locks. The Viper line has many options that also include top-notch security alarms.


Keyless entry does not work for 97 Pontiac grand prix gt - The remote does work but will not lock or unlock the doors.?

Stand outside your car holding the remote up against the Driver side window. Hold the Lock and Unlock buttom simultaneously on your remote while pointing your remote at the steering wheel. After about 30 sec. you will hear your horn beep. Your remote has been re-set and should now work.


What is the remote programming procedure on a 2000 trans am?

hold down the lock and unlock buttons down at the same time for about 8 seconds on the remote. this should re-set the code.


Keyless entry for a 2005 Chevy trailblazer - you cannot program a new remote - you go thru the steps to reset and after following the instructions you cannot set a remote what other issue could you be?

One of our forum members can probably help you out at www.trailvoy.com Enthusiasts helping other Trailblazer owners!


How do you set the idle on a 1992 Chevy Corvette?

Idle is set by the computer.


How to set timing in a 1988 Corvette?

Figure out your engine type, then ask how to set timing on a 1988 corvette ***** engine. That should help you a great deal.


How do you set the clock on a 1989 Corvette?

To set the clock on a 1989 Corvette the radio must be turned off. After turning the radio off hit the set button and then hit scan. The time can be set using the arrow buttons.