on my 2000 s-type, the drivers door panel is held on by 2 screws located in the interior door pull under the small rubber mat. remove those screws and pry the panel off. pry the panel off from each snap on position, being careful not to damage the snap mounts.
To put a window back on track in a 1996 Geo Metro, the door panel will have to be removed. Use a screwdriver to pry up the clips around the door panel. Then locate the window cable and rewind it. If the window is operated by a power switch, be careful not to pinch the fingers when rewinding the cable.
Opening the driver door of a 2000 Cadillac Seville is easy. All you have do is pop off the door panel.
The XJS ceased production in 1996.
Go to this website. It will show how to remove the door panel.
Magic
by taking door panel off
You will need to remove the screws in the door. They are located in the door handle, the door latch and at the very bottom of the panel. Once you remove the three screws pull the panel and it will pop out.
To remove and install a door mirror on a 2000 Mitsubishi Mirage, the door panel needs to be removed on the inside of the door. First remove any light lenses in the door, then unfasten the clips holding the door panel on. Then remove the mounting bolt for the mirror. Put in a new mirror, replace the door panel and the light lenses.
Remove the screw under the door latch
Hi there,I have just worked on my o/s/r door, and mine was locked shut ! so here it is.1. remove the screw under the door handle, below the ashtray area, which holds the panel against the door.2. remove the small plastic disc and then the screw holding the door release handle cover panel.3. idealy you need a screwdriver with a 90 degree bend near the end, say 1", to put in between the door panel and door, then starting at the bottom of the panel, pull the panel out from the door, good sharp tug, it is held on with 6 or 8 plastic pins, once released you then move the panel upwards to lift it off the top door edge.4. then release the wiring connectors from the speaker, elec window switch, and lower door light.now you are in.........
Remove the rear door panel.
Using a screw driver, remove the screws and remove the clips from the door panel. Remove the panel slowly, remove any wire connections, and pull the panel off the door frame.