upper or lower? either way, remove all wiring, 8 10mm bolts that hold upper intake, both fuel lines in right rear(inlet, outlet) remove upper intake. 8 13mm bolts hold lower intake. dont need to remove lower intake if u r replacing injector assemble which is probably what u r doing as this is a very common problem with the vortex engine. be sure to replace as assembly and not just regulator if the vehicle has 100k plus
The starter is located under the intake manifold, and you will have to remove the intake manifold to get to it. Do not forget to buy a intake gasket before you take it off, because they always fall apart when you take the intake manifold off.
my dad and me took off the manifold and air intake off to get to it. and it didn't take more than a hour
how to replace intake manifold for 1994 ford falcon ED
Remove the intake manifold and take it to a welding shop that works with aluminum. Let them determine if it can be saved or not.
The intake manifold is underneath the plastic silver cover held down by four nuts. Take it off and you'll find the intake manifold - also plastic. Even more unusual, the starter is underneath the intake manifold!
It depends on what you have to remove to get the intake manifold off. Once the intake manifold is off it will take about an hour.
under the intake manifold
It is your Idle Airflow Censor. It is located behind your air intake manifold by two screws. Take it out and clean it off and it will fix your problem.
it is under the intake manifold. you need to take the fuel rail off and take the intake manifold off to get to it it sits in the valley between the cylinder banks
To remove the intake manifold on a 2004 Mitsubishi endeavor, you should take it to a mechanic. An authorized dealer will also fix it for you.
Between the head and the block. First, remove intake manifold and exhaust manifold. Take the valve cover off and unbolt the head. Then, pull the head off and you'll see the gasket.
take all the wiring and hoses loose from the top of the engine, and you might have to remove the valve covers. then just loosen the intake manifold bolts