Oldsmobile Intrigue
Ford F-150
Scooters and Mini-Bikes
Honda Motorcycles

How do you take the governor off of a 2000 Oldsmobile Intrigue?

828384

Top Answer
User Avatar
Wiki User
2015-07-16 18:20:37
2015-07-16 18:20:37

I don't believe it is possible. The regulation or "governor" is computer controlled.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

You can't take off the "governor" on any computerized car.

User Avatar

take out the old one then put a new one in the same way you got the old one out

User Avatar

How can i take off the alarm on my 1999 oldsmobile intrigue?

User Avatar

If the "oldsmobile" was made in the last 20 years, it is computer controlled.

User Avatar

looks like a normal sensor, I have a 2002 intrigue, it is located just above the starter, you have to take out the starter in order to take it out.

User Avatar

just above the starter on the front of the motor. will have to take the starter off to get to it.

User Avatar

you take the old one out and replace it with the new one... hope this helps

User Avatar

Itd in the top middle towards the back in that whole system of pulleys its the one that take a 5/8 wratchet

User Avatar

Take it to a mechenic asap....lady%preach

User Avatar

If you do it yourself, the VC gaskets are $53.00 bucks at Autozone, and it will take you all day. If you take it to the stealership, they will charge you twice that in parts and about 3 hours of shop labor. So you will probably plop down something just shy of $500.00.

User Avatar

The only way I know is to take it to the dealership. Some are suppose to charge $40 for this.

User Avatar

Its in your manuel. Turn key to start wait ten mins and then turn off then turn on it should reset. if not take to dealer.

User Avatar

Looking at the front of the car, it's on the passenger side, just in front of the radiator, about half way down. Have to take the radiator out to get to it - It's a pain.

User Avatar

Took me about an hour to change mine, but it was the first time.

User Avatar

To remove the door panel on a 2000 Olds Intrigue, remove the lenses off any lights in the door. Then remove the screws holding in the light assembly. Using a screwdriver, gently pop off the clips in the corners and on the sides.

User Avatar

behind left back wheel is where it is mounted. take off the plastic shroud under cas cap. remove from bracket, remove 2 hoses and 1 plug on purge solenoid.

User Avatar

The best thing that i found to do is take a pliers and stick the handle end in the rivets and stick a screwdriver in between the pliers and take off that way

User Avatar

I just paid 1688.95 to have my 1998 intrigues head gasket repaired. According to the shop it normally cost between 1500.00 and 1900.00 depending on the severity of the damaged when they take it apart and take a look.

User Avatar

If it has a 3800 Series II motor, the capacity is 4.6 US Quarts. If it has the 3.5 'Shortstar' motor, then it will usually take 6.0 quarts (Including a filter change in both cases)

User Avatar

You need to take the back seats out. The lower part of the seat just presses in at the front. Where your ankles would be if you are sitting in the seat. Once you get that out you can see the bolts that hold the top/ back in.

User Avatar

they are under the coil packs which are in the top of the valve cover, unplug the coil packs, take out six bolts, the wires should come out with the coil packs and you will have access to the plugs.

User Avatar

Do not take a radiator cap off. Fill from the overflow tank or you will add air to the cooling system and it will have to be bled off or your engine will overheat.

User Avatar

disconnect the battery for ten minutes, then reconnect. turn over key, do not start, leave key in run position for like a minute, take it out for ten seconds, and try to start. If it doesnt start try again without disconnecting battery. That is how i bypassed the security in my 2000


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.