there is a screw at the very front towards the winshield take it out and the unit should come down. take out the front compartment shield it should be empty, then make sure your clips are in place and put screw back in this is made easier with having the shield off when tightened replace shield
Open the cover and locate the screws on each side of the console. Remove them with a Phillips screwdriver. The console will get a little loose. Do not pry it now or intend to remove it by pulling the loose end. Get the part of the console that is close to the windshield and try to get your fingers in between the ceiling and the base of the console. Pull the console down once you are able to grab the cover. Remove the connector. Installation is the opposite.
sounds like it could be a loose connection.
Sounds like you left a retaining clip loose on one of the pull rods.
My belt is too loose, I have to tighten it.
if it is loose under the console storage, it is probably the bracket under the storage bin. Remove the two screws holding the lid and the two screws by the latch hole and the two screws on the bottom to remove the inside of the storage area. Once you get it out you might see that the bracket that the screws on the bottom of the storage bin go into is broken. You can get a replacement bracket for about $80.00. You have to remove the console to replace.
To tighten a loose drive belt, find the pully that is connected to the belt. Tighten the pully and then hold the belt in place using the adjuster belt. Check out the related video to see an example of how this is done.
You can not tighten a T-Rod end up. If it is loose then replace it.
Cannot tighten, Replacement is the only fix for loose transfer case chain.
No, it will need replaced.
NO! they're not supposed to be loose if they are use the yellow thing to tighten it.
Pry loose the lens cover and remove the two screws underneath. Then open the sunglass cover and remove two more screws. Disconnect the wiring harness. That's it, at least for the 2001 and similar models.
Vinegar doesn't do anything.