0
How do you time a 91 s-10 blazer where is the wire to set it to timing mode?
Wiki User
∙ 16y ago
the wire is under the dash next to the ecm on the passenger side
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you put the distributor in mode to set timing on Chevrolet's V-6 4.3 Blazer?
there is a timing connector, this is usually a tan wire with a black tracer..it is usually located under the carpeting close to the heater cox on the passenger side of the truck
Wire for electric spark timing in bypass mode tan and black striped wire?
Yes, that is the one you unplug.
What is the function of a single wire timing connector bypass on a 1992 5.7?
When it is disconnected it puts the electronic timing control module in limp mode,and then you can set the timing with a timing light.
Where on a 95 Chevy Blazer LT is the timing reset wire you know its under the glove box but is it a single wire or in a group also what are the steps to set the timing?
The wire in question is not called a reset but a "Bypass Wire" . It is a single wire with a quick disconnect found right next to the main harness entering the computer module . The bypass wire is used when setting the base ignition timing to 0* . You will not be able to properly set timing with the control wire connected .
Where is the wire that you unplug to set timing on a 1994 Chevrolet truck?
I just set my timing and the plug on my 1994 full size Chevy Blazer (same as a full size pick up) was directly under the glove compartment. It was one wire (tan with black stripe) and two ends of a plug together just unplug and set timing.
Distributor bypass to check the timing on 94 full size blazer?
Look under the dash for a single wire connector right side under the glove box.
How do you adjust and set the timing on a full size Blazer 4 bbl?
Put your timing light on the number one spark plug wire and then remove the vacuum advance hose, loosen the distributor bolt and with the engine idling move the dist. unti, you get the timing mark on the crank to come to the correct notch on the timing guage.
How do you wire a fuel pump pigtail on a 97 Chevy blazer?
How do you wire a Pigtail for a Fuel Pump on a 97 Chevy Blazer Thank You EVa
Is there a wire to unplug to time a 97 vortec chev engine?
NO there is not. The timing on that engine is computer controlled and it REQUIRES an engine scanner to set the timing. A timing light will not work.
How do you set the timing on a 1988 fuel injected Chevy S-10 pickup with a 2.8 V-6 engine with an automatic transmission?
you have to undo a single wire plug under the carpet on the pasenger side. then the computer is in sleep mode. Set at 0 degrees, then shut off, reconnect the plug and start,,,, it will automatically adjust itself.
At what degree is the timing set for a 91 4cylinder in an s-10 Chevy truck with an e engine?
Make sure the ECM is in field bypass mode (disconnect the tan wire in the passenger compartment) and set the timing at 0 TDC.
How do you adjust the ignition timing on a 1992 Pontiac Firebird?
disconnect the tan wire connector on the passenger side wiring harness , that puts it in bypass mode, unlock dist. bolt and adjust timing. when set reconnect wiring connector.
