0
its actually called a castle nut, it only works on the right type of bolt, once its tightened on just simply push the pin(it should come with a pin)through the nut and bolt and it locks in place.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where does a lock nut go?
A lock nut should go on a bolt before a washer or the nut.
How can i stop my rc cars wheel nut from wearing away at the rims and coming off?
Use lock-tite and washers
What size rivet should you use for a 2002 Pontiac sunfire window regulator?
You can use a bolt and lock nut, probably 1/4 inch.
Does it have lock nut?
Yes, if one has been fitted.
How do you loosen a lock nut under the bathroom sink basin?
You need a pipe wrench. Try to borrow-they are pricey.
How do you adjust parking brake on 2001 dodge 3500 disk brakes?
If the truck has disk brakes in the back then you have to adjust the emergency brake cable underneath the vehicle by loosening the outer lock nut then tightening the adjuster nut and then you re-tighten the outer lock nut down to the adjuster nut.
How do you adjust clutch on a Honda fourwheeler?
Loosen the lock nut a few turns. Use a flat screw driver to turn the adjustment screw in the middle of the lock nut. Turn the screw CCW (in the direction the decrease play arrow points) until you feel resistance, turn it back the opposite direction a quarter turn and then turn the lock nut until its tight. This is what I read for my 2000 Rancher ES in the owners manual, but I used it on my 85 fourtrax.
What size is the lock nut or hub nut on a 2000 kia sephia?
The Socket Size for a 2001 Sephia Is a 32 mm
How do you remove lock nut on rim?
You're meant to use a specially keyed socket. If you don't have that, tire shops usually have a set of removal Tools.
1985 Nissan pickup parking brake adjustment?
look under driver side by ddoor,unscrew lock nut and tighten other screw until brake is good,then tighten lock nut.
How do lock washers work?
A lock washer overlaps itself when it is new so that when you tighten the nut down the pressure causes it to flatten out and in turn put pressure against the nut and whatever it is against. The pressure plus the gap in the washer helps prevent the nut from turning.
How do you remove top nut on shock without the whole thing turning 94 Chevy pickup?
Use a pair of vise grips and grasp the shaft tightly and lock the vise grips. This will hold the shaft while you remove the nut.
