After torqueing I would use a regular ratchet with the angle gauge so you don't damage or through off the torque wrench calibration.
Yes, you can use a torque wrench in both directions.
Use a torque wrench that is graduated in ft. lbs or do the math.
I think you mean a Torque wrench. Typically it will either have a gauge on it or it will click to let you know you have reached a certain amount of pressure on a bolt/nut.
A torque wrench, usually a power torque wrench
Torque wrenches depend on a modern generalisation of Hooke's Law. The deformation of an elastic material (even the steel out of which parts of a torque wrench are made) is proportional to the stress to which it is subjected. When you use a torque wrench part of it follows the thing your turning and part of it does not. That part of the torque wrench twists slightly; it's being deformed and obeys Hooke's Law. The more twist, the more torque is being applied. The needle amplifies the amount of twist so that you can read the torque on the gauge.
as long as your extension is 90 degrees from the handle it will not affect your torque wrench. if you use a super long torque wrench you may lose a little torque in the extension it self but should not affect torque. an extension affecting the wrench in lenght like a crows foot will affect torque as long as your extension is 90 degrees from the handle it will not affect your torque wrench. if you use a super long torque wrench you may lose a little torque in the extension it self but should not affect torque. an extension affecting the wrench in lenght like a crows foot will affect torque
You don't use a torque wrench to loosen ANYTHING. -It is only for tightening nuts and bolts to the correct torque.
No
An Impact wrench is for a totally different use. A torque wrench will let the user know when a certain torque has been achieved in tightening. The impact wrench is for removing very tough nuts under impact of a hammer.
From my knowledge, it should click when you hit the right pressure. The gauge should have some indication of tightness, or you're missing something.
spanner or a torque wrench
Use a torque wrench with the correct setting for your motor. See related link.