0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the tachometer resistor in a 1995 pathfinder?
in the wire hrnes at front of intake plenum
Can you swap a turbo engine for a non turbo engine in a 92 eclipse?
Yes you can you will need to get the non-turbo engine, non-t ECU and wire harness. The wire harness and ecu are diffrent between the t and the non t.
What is needed to install a tachometer in a dunebuggy with a 1970's vw motor?
a tachometer, wire and wire terminals
Where is the tachometer sensor located on a 1995 Ford F250?
look at your trany it should have a wire going into it on the top side in the middle
How do you install a tachometer into a 1999 Mitsubishi mirage?
White wire coming from the distributor.... remove a section of sleeve from wire and splice the signal wire from tachometer to it!
Where is the tachometer wire on a 1996 Ford Windstar GL?
i dont know whwere is the tachometer wire of 2001 ford windstar
Could some one help could you tell you where the tachometer connection is on a 1991 Chevy s10 4.3 Leter is on the distrubutor with the four wire or the two wires?
Green wire on the distributor is the tachometer pick up. Green wire on the distributor is the tachometer pick up.
What color is the tachometer wire on 1988 camaro?
YELLOW
How do you wire a tachometer to a Yamaha dirt bike?
I think you can by attaching it to you spark plug wire
How do I install a tachometer in my Chevy truck?
Use an inductive pickup on plug-wire #1, and connected to tachometer located in vehicle.
Where are the tach-RPM wire dimmer wire and power wire cables on a Hyundai Accent GL 1.6 hatch DOHC that an aftermarket tachometer connects to if the car does not have a factory installed tachometer?
this depends on the year, that will determine the type of ignition and the conection.
How do you fix the tachometer on a 91 Acura Integra?
The tachometer on a 1991 Acura Integra is wired through the dash. To reach the wiring remove the dash console and pull out the tachometer. There the wiring can be worked on using a spark tester to find the bad wire and solder unit to replace the wire.
