Disconnectr the wires from the switch and connect them together
Disconnect the 2 wires from the switch and connect them together
Red
The neutral safety switch is on the side of the transmission. It screws into the side and has a small three wire plug.
The safety switch is located under the radiator belt. You can trace the positive wire from the battery and it will end up at the safety switch.
The year, make and model would help.
To override a neutral safety switch, locate it (it should be at the base of the steering column) and remove the green and brown wire. Connecting these two wires together will bypass the safety switch and your reverse lights will turn on.
Follow the positive cable wire from the battery and it will end up plugged right into the safety switch.
Three wire switch on the driver side of trans, just above oil pan.
The neutral safety switch is located on the driver side of the transmission on the shelf part of the trans.. It screws down into the trans. and has a four wire plug connector.
The Neutral Safety switch enables the vehicle to ONLY start in either Park or neutral for Automatics and Only when clutch is engaged in vehicles with a manual Transmission. The switch will either work or not work. Their is no slow fade in operation. If the neutral safety switch is bad it will not send a signal or ground out the transmission so the vehicle will start. ALSO...If the wire leading to or from the switch is frayed , cut, or disconnected, the vehicle when not be able to start as well.
dont....just replace it..its safer........
When the neutral wire goes to the switch