There is two small holes in the chrome cylinder where the key goes in. Take a fine pick preferably a mechanics pick and it's nice if you have a key but you really don't need one. Push the pick in the lowest hole to release the spring, with the key turn left and pull out. Without the key old school a screw driver without damaging the outer casing and twist the same way as with the key. The casings are cast and they can easily be damaged. Easiest way to just buy a new casing with ignition from east coast Chevy $36 and a lock for $23 then its all new. You can buy the whole set for $76 doors, trunk, ignition, and glove box. Hope this helps Lyle Davidson
Remove the retaining ring from the top of your 1997 Chevrolet 1500 ignition cylinder. Slide the ignition cylinder out and remove the wiring harness.
You will need to remove the retaining ring from the top of your 1975 Chevrolet pickup truck ignition cylinder. Slide the ignition cylinder out and remove the wiring harness. Reverse the process to install the new ignition cylinder.
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
You can remove the 2000 Chevrolet Astro Van the ignition switch cylinder by removing the retaining ring. The retaining ring will need to be turned to the left. The ignition switch cylinder will slide out.
oDon't look for it here n
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
Begin by removing the retaining ring at the top of your 1996 Chevrolet Silverado ignition lock cylinder. Slide the ignition lock out and remove the wiring harness. Reverse the process to install your new ignition lock cylinder.
Remove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.
You will need to remove the retaining ring at the top of your 2003 Kia ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness from the back of the ignition cylinder.
You will need to remove the retaining ring at the top of your 1979 Chevrolet El Camino ignition switch. The ignition switch will slide out. Remove the wiring harness. Reverse the process to install the new ignition switch.
if it is the ignition lock cylinder, first disconnect the battery, you need to remove the steering wheel ,turn signal switch , etc, then you need to insert the ignition key into the lock cylinder, turn it to the run position,then pull the cylinder out, reverse the operation to install the cylinder,
There will be a pin on the front bottom of the cylinder housing. Turn the key to the on position then push the pin in and pull the cylinder out.