answersLogoWhite

0


Best Answer

Remove belt guards, loosen alternator hold-down bolt, loosen belt tensioner, remove belt, unhook Power Steering line clamps and lines at reservoir, remove reservoir and pump.

Reinstallation is reverse of disassembly.

User Avatar

Wiki User

โˆ™ 2009-12-27 03:50:29
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How does one replace the power steering pump in a 1994 Subaru Legacy Proper procedure for removing the reservoir?
Write your answer...
Submit
Related questions

How do you replace a power steering reservoir for a 2000 odlsmobile interigue?

How do you replace a power steering reservoir for a 2000 odlsmobile interigue?


Where is the power steering filter on a 2003 dodge caravan?

It's built into the power steering reservoir. To replace it you need to replace the whole reservoir. Fortunately, this is an inexpensive part... ($30).


How do you replace a water thermostat in a 1993 Lincoln mark viii?

It is under the power steering reservoir and can be removed by removing two bolts. It has three hoses going to it


How do you fill power steering fluid?

Turn off the engine. Locate the Power Steering reservoir. To prevent dirt entering and causing damage to the system, clean around the cap before removing it. Remove the cap, Fill reservoir to the correct level, replace the cap. Clean up any spillage.


How does one replace a car steering wheel cover?

You can replace a steering wheel cover by first removing the old steering wheel. Once complete, wash and dry clean the steering wheel and then apply your new steering wheel cover.


How do i tighten my leaking power steering reservoir 97 Ford Ranger 4-cylinder?

Seals are probably shot. Replace the pump/reservoir assembly.


How replace power steering hose BMW 740?

The power steering hose on a BMW 740 is replaced by placing a drain pan under the vehicle, removing the hoses with an open ended wrench, and screwing new hoses into position. The reservoir can then be topped off while the steering is moved from side to side to remove air bubbles.


What is wrong if power steering fluid is leaking all over the power steering reservoir with smoke coming from it when the car is driven?

You need to replace the power steering pump. If it is leaking, it is going out.


How do you replace the power steering belt on a 97 Plymouth Breeze with a 2.0 4-cylinder engine?

how to change the reservoir of a power steering on breeze 1998


How do you replace blower motor on a 1992 Buick Century with the power steering reservoir and pump in the way?

You may have to vmove them to get at it


How to fix leak from the steering gear boot?

Check the fluid reservoir. If the fluid level is low, you have a leak in the powering steering system. The problem could be a damaged steering rack. You will need to replace the entire steering rack.


Can you replace the ignition lock cylinder on a 1994 Pontiac firebird without removing the steering wheel?

You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.


How do you replace the alternator on a 2005 Ford Focus?

I just pulled my alternator out of my 2.0 2005 ford focus. you have to remove it from the top. Removing the power steering fluid reservoir, Radiator reservoir, and the heat shield from the exhaust. Good luck. It wasn't fun. Also I am having a hard time finding a replacement under $250.


How do you replace the ignition cylinder 1992 Bonneville?

I have not seen a way to do it without removing the steering wheel (and airbag).


How do you replace the windshield washer pump in the reservoir on a 99 GMC Sierra?

after removing the reservoir gently pry out the old pump and lube the o-ring for the new one with lite oil


How do you replace Power Steering Fluid for 1986 Jaguar xj6?

Jack vehicle under centre of front cross member just enough to lift tyres off surface. Place a suitable container under the Power Steering Fluid Reservoir. Remove the lower hose (inlet to pump) from the reservoir. Allow fluid to drain into container. Replace hose and fill reservoir with new fluid (Cap is LH thread). Start engine and exercise power steering rack from lock to lock several times to purge old oil back to reservoir. Again remove hose from reservoir and allow to drain. Refill reservoir and again exercise steering. Check fluid level and top up as required.


Where could a power steering unit be leaking?

most likely your alero's power steering pump would be leaking from the power steering reservoir, but as an alero owner i have had to replace the whole pump because the pump shaft snapped on me


Can you replace the turn signal switch on a 1996 Mitsubishi Montero without removing the steering wheel or airbag assembly?

no.


What components of the steering column make noise when turning?

power steering pump is low in fluids or the pump itself is bad. replace power steering pump if fluids checks out ok. makes sure not to over fill reservoir


How do you change the dimmer switch on a 2002 VW beetle?

The dimmer switch is said to be included with the steering column switch. Before replacing disconnect battery and removing steering wheel. After removing the steering column switch trim, unscrew hex bolt. Remove and replace switch and return components.


Sc400 how to replace power steering pump?

There is 3 bolts and the hose lines which need to be removed after removing fan belt


Gmc jimmy air bag clock spring how to replace it?

The clockspring is replaced by removing the airbag, and by removing the steering wheel. From there disconnect the old clock spring, and put in the new clock spring, and replace everything in reverse order.


Why does the power steering reservoir empty when you start the car on a 1992 Chrysler new Yorker?

Look for where the flu I d is leaking out. Repair or replace as required.


How to replace power steering pump on 1979 Chevrolet 350?

The power steering pump on a 1970 Chevrolet 350 is replaced by removing the v-belts, disconnecting the pressure lines, unbolting the pump, and removing it from the vehicle. The new pump can then be put in place and bolted up.


How do you replace high beam switch for 2001 impala?

steering wheel has to be taken off to loosen the upper cover on the steering column and under the cover the switch can be taken out by removing a few screws.