0
How does the master-slave clutch work together. just replaced the Slave cylinder and the pedal still goes to the floor?
Wiki User
∙ 15y ago
You need to bleed the system like you would a brake system. This requires a friend (or you can buy a bleeding system). Have you friend press and hold the clutch down. Release the bleed bolt on the slave cylinder and air should come out. Tighten the bleed bolt. Have you friend pump the clutch a few times and hold it down. Release the bleed bolt and air with some fluid should come out. Tighten the bleed bolt. Continue this process until no air comes out and just fluid from the bleed bolt on the slave cylinder.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
When do you bleed your clutch?
after the clutch master cylinder has been replaced.
Should you replace your clutch master cylinder when replacing clutch?
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
Is your clutch going bad in your 1995 Toyota Paseo I have replaced master clutch cylinder and slave cylinder?
Does my 1995 Toyota Paseo have a clutch cable
How do you know when the clutch master cylinder is gone in a 1995 escort?
Whenever you are having a problem with the clutch disengaging the engine from the transmission it is advisable to bleed the clutch slave cylinder. If the clutch can't be operated by bleeding the slave cylinder then the clutch master cylinder is gone and should be replaced.
Why does my Zx2 Clutch pedal stick?
clutch master slave cylinder just replaced mine and now it doesn't do it
Where can you find the Clutch slave Cylinder on a 1989 Nissan Pathfinder?
The Clutch slave cylinder is located on the passenger side of the bellhousing.I recommend to replace the Clutch Master cylinder also;if either one is replaced , the other will fail in no time.
How do you pump up the clutch in a 1984 Nissan 300 ZX?
If the clutch stays on the floor after you push in the clutch first check to see if you have clutch fluid in the reservoir, if you do then it could just be because the clutch needs bled. If that doesn't do it then maybe your slave cylinder needs bled or replaced. From what I have seen it is generally because the slave cylinder needs replaced. Not to confuse you but the things that make up your clutch system are the clutch master cylinder, the slave cylinder, and the clutch dampner. If it is because the clutch needs bled start with the clutch master cylinder then do the slave cylinder. If it is not because of lack of fluid then check up under the dash and see if the spring on the clutch pedal is attached. Hope that doesn't sound to confusing.
Why is it hard to shift into first gear second gear and reverse after having the clutch replaced as well as the master cylinder and slave cylinder?
bleed your clutch..that may be the problem
What would cause clutch fluid to leak from the slave cylinder so when you start the vehicle the clutch stays to the floor and is floppy with no resistance?
The slave cylinder has failed and will need replaced.
How do you adjust hydraulic clutch on 92 standard sl?
Hydraulic clutch on that model is not ajustable. You either have a bad clutch slave cylinder, Or the clutch and pressure plate needs replaced.
Why is the clutch pedal still sticking after clutch replaced in alpha romeo?
you need to change the spring in the clutch cylinder ,you find more info on at alfa .net
Where is the clutch bleeder on a 95 jeep wrangler the master cylinder broke you replaced it and cant find the bleeder screw it is not on the slave cylinder?
== == == ==
