Want this question answered?
remove rear drive shaft. remove pinion yolk from front of diff.remove oinion seal replace with new one. replace pinion yolk, replace driveshaft,.. dhceck ujoints of drive shaft while out, its a good time to replace them
Front pinion. So you have 4wd. Its not the end of the world. Remove drive shaft. Bolts in the middle. Then remove the pinion seal. It will definitly suck on your back. Try to find a lift.
The drive shaft does not leak. It is either the pinion seal or the trans. seal. Either one, the drive shaft has to be removed. The rear seal should be done at a garage, but you could do the front.
Pinion seal: Remove the drive shaft from the yoke. Pull the pinion yoke off the pinion shaft. Remove the old seal and hammer on a new one. Seal is about 10 bucks. Re-assemble Rear cover: Remove the cover bolts. Put a pan under the rear end and pry the cover off. Clean and re-silicone the cover Re-assemble. WARNING!!!!! Don't let the rear end run dry, will cost you pinion bearings in a very short time.
Replace it!!
Well. First you have to suck my fat dïck. Then whatsever the fu*k else to fix your piece of sh*t fourwheeler
there is no fixing you have to replace the rack and pinion
Not very long as it is only an emergency repair. The only fix for a blown head gasket is to replace it.
Replace the seal.
Replace the seal.
well.. u can seal it with m-seal or any other adhesive to fix the problem!! as simple as that!!
Rough estimate for replacement $400. ROUGH ESTIMATE FOR RACK AND PINION IS $800 THAT IS PARTS AND LABOR.