0
How many grease fittings are there on a 1988 Chevy silverado 2wd?
Racyta
Can be anywhere between 6 and 12 but most likely 11 or 12. places to look are upper and lower ball joints on both sides, tie rod ends on both sides. stearing linkages and there should be one on the pitman arm.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Where are the grease fittings on the rear tie rod ends on a 1988 corvette?
On the rear Rod and's, in your 1988 Chevrolet Corvette, are located on the axles. A complete diagram of the grease fittings can be obtained from most auto-parts stores.
How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
How much hp does a 1988 Chevy Silverado have?
not enough
Where are the grease fittings on a 1988 Ford F-350?
Drive shaft, steering knuckles, and pitman arm
What is the blue book value of a 1988 chevy silverado?
1500.00
What is the gross weight of 1988 Chevy silverado k2500 with the 5.0l engine?
The gross weight of a 1988 Chevy Silverado K2500 with a 5.01 engine is about 2.5 tons. This is equal to about 5,000 pounds.
Where is the starter on a 1988 Chevy Silverado?
on the roght side below the manifold
Is the Chevy 5.7 silverado fueled injected?
It is if it's a 1988 or newer.
What transmission is in a stock 1988 Chevy silverado with 305 engine?
Should be the 700R4
How many oxygen sensors on 1988 Chevy silverado have 350 motor?
It has 1
Has a 400 transmissin ever came in a Chevy Silverado?
Yes in the 3/4 ton silverado trucks before 1988
Will a 95 silverado power steering bracket fit your 89 silverado?
yes, Chevy truck brackets are the same from 1988-1995
