3 times
some times you have to reset the computer.
Some times. Go to Auto Zone they will check codes and reset your computer for free...
Its very easy to reset computer of Xsara Picasso most of the times all you have to do is disconnect the battery for half an hour, then plug it back in. This normally should reset a multitude of computer problems that may occur .
you have to put the key in ignition, and turn the key to on and lock for ten times. this will reset the computer only . unhooking the positive from battery will do nothing with lights on dash if problem, wasn't repaired.
No, Remove the battery for over 30 minutes. this will reset your computer. Assuming something isn't terribly wrong. then the same code will just run again.
My husband said that you could disconnect your battery for about 10 minutes, and alot of times that works.
Turn key on without turning on the engine then press the gas pedal 4 times. The computer should then reset.
Most times when the time never stays set after powering off one's computer, is an indication that the "CMOS" battery needs to be change. The "CMOS" battery is the little flat silver disc on your computer's mainboard that is responsible for storing all the settings including time and date. Note: Chances are though that when this battery goes out other settings will change back to default on your mainboard. Unless you are experienced with how to set your computer's settings, it would be advisable to let someone that is familiar with such things handle that for you.
Turn the key to "on" but do not start the engine. Push the gas pedal to the floor 3 times in quick succesion. The change oil will flash 3 times to let you know it has reset.
Disconnect one cable of your battery and turn the car key to ignition position two times, connects your battery and turn the car key to ignition.
Most times you can reset the computer yourself by disconnecting the battery for thirty minutes. If that fails then almost any qualified mechanic shop can service first generation explorers.
Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.