0
If you turn you key on and off three times will this reset your computer?
Wiki User
∙ 13y ago
No, Remove the battery for over 30 minutes. this will reset your computer. Assuming something isn't terribly wrong. then the same code will just run again.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How many times do you turn key off and on to reset computer after battery change out?
3 times
How to reset service light on Renault master?
it needs to be reset by computer Turn off power. Press accel pedal to floor. Turn keys two notches. While pressing the accel press brake three times. Depress accel and turn off keys.
How do you reset the computer after the oil has been change for a 2005 Chevy Cobalt?
Turn key on without turning on the engine then press the gas pedal 4 times. The computer should then reset.
Where is the oil reset switch chrysler 300 2008?
To reset the oil change due message,Turn the ignition on, press the gas pedal to the floor three times, cycle key off and on.To reset the oil change due message,Turn the ignition on, press the gas pedal to the floor three times, cycle key off and on.
How do you reset the service light on a vauxhall zafira?
1. TURN IGNITION OFF 2. HOLD TRP COMPUTER RESET IN 3. TURN IGNITION ON 4. STILL HOLDING TRIP RESET, WAIT FOR THREE DASHES ON THE DISPLAY 5. TURN OFF IGNITION. 6. RELEASE TRIP RESET. 7. TURN ON IGNICION TO CONFIRM SERVICE LIGHT HAS GONE OUT.
Buick allure 2005 how to reset oil change light?
Turn the key to on, do not start, push the gas pedal to the floor three times, the light should flash on the dash indicating the reset. Turn the key off. You should be reset.
How do you reset the computer after changing the turn signal switch?
You do not have to reset the computer after this repair. If the Check Engine Light is on it is not because you made this repair. If you disconnected the battery the computer will reset itself.
Will you need to reset your check engine light after replaceing your thermostst?
If the light is on, you will need to have it reset, or wait for the computer to run the self test enough times to turn itself off.
How do you reset the change oil light in a 2001 Chevy Silverado?
Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.
How do you reset oil change on dodge caliber?
Turn key to on position depress the acceleration pedal slowly three times then turn car off...
How do you reset brake service light in a 2000 Chevrolet suburban?
turn key to on. press gas pedal three times. turn off key. this resets light. turn key to on. press gas pedal three times. turn off key. this resets light.
How do you reset the driver information center on a 1990 Bonneville sse?
turn your key to the on position and pump the brake three times. Or turn the key on hold the dic button until it changes and then pump the brake three times, that should do it.
