0
How many transmission to engine bolts are there on a 1998 suburban 350 vortex?
Wiki User
∙ 13y ago
There are 6 bolts in the bell housing that hold it to the rear of the engine.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How many bolts connect the bellhousing to the engine for a 1996 Chevy blazer with a 4.3 liter vortex engine and an automatic transmission?
There are 6 bolts that hold the trans. to the engine block.
How many bolts hold the transmission to the engine on a 1995 K1500 Z71?
6 bolts hold the transmission to the back of the engine.
Where is bell housing 1994 chrysler New Yorker?
It is the part of the transmission case that bolts to the engine.It is the part of the transmission case that bolts to the engine.
How do you replace a transfer case on a 2001 Chevy Suburban?
take out 6 bolts from the rear of transmission
Where do you hook engine stand on back left of 1996 Chevy Blazer engine?
The engine stand bolts up to where the transmission bolts to the back of the engine.
Where is the bell housing on 1999 dodge ram truck 5.2L?
The bell housing is the front of the transmission, the end that bolts to the engine.The bell housing is the front of the transmission, the end that bolts to the engine.
What could cause the starter bolts to break on a 99 suburban?
engine backfire during cranking.
How many bolts are in the bell housing of a transmission for a 1986 Chevy truck 4x4 with 305 motor?
There are 6 bolts that holds the transmission to the engine.
Will the transmission from a 1988 4x4 suburban fit into a 1978 gmc 4x4?
if the bolts line up but u'll have to replace flywheel or the torque converter, check spacing of bolts
Can the flywheel be removed and replaced without removing engine or transmission i'n 1978 Chevy 350 motor?
NO. You will have to remove all the transmission bolts and slide the transmission back enough to get a wrench and your hand between the engine and transmission to remove the fly-wheel bolts.
Where is a transmission resivior for 2000 Lincoln ls?
There is NO "Reservoir" for a AX4N, Automatic Transmission. There is an oil pan and a torque converter which is between the engine and the transmission where it bolts to the engine.
How replace flex plate in subaru legacy 96?
You have to pull the engine or transmission. The Flex plate is at the back of the engine on an automatic transmission. 6-8 bolts hold the plate to the engine, and four bolts hold the plate to the tranny.
