Want this question answered?
No, you cannot use a 10 amp switch to open a window in a 12 volt DC system. This is because the switch would not be able to handle the current necessary to power the window motor. The amount of current required to open a window in a 12 volt DC system is typically much higher than 10 amps, and so the switch would not be able to cope with the load. In addition, the switch would not be able to sustain the current necessary to keep the window open, which could lead to the window becoming stuck in the open position. Furthermore, the switch would not be able to handle the circuit protection requirements necessary to keep the window safe. For these reasons, it is not recommended to use a 10 amp switch to open a window in a 12 volt DC system.
(volts x amps)/1000AnswerThe 'volt ampere' (V.A) is the unit of measurement for apparent power of a load, and is the product of the supply voltage and the load current. To convert volt amperes into kilovolt amperes, divide by 1000.
for given power,High voltage transformer requires more insulation in window from phase to phase and phase to core.Amount of insulation in window increases and net copper area will decrease,Window space factor=(Net copper area in window/window area)Kw = Ac/AwHence, with increase in voltage rating,net copper area decreases and ultimately window space factor reduces.
yes
In the United States, I am unaware of any minimum distance required from a window. There may be a local code where you live or work that establishes a requirement.
Receip or Piston type compressor are used for large duty cycle work (A/c or other equipments), energy hungry but last longer (Heavy Duty). Where as rotary compressor are energy efficient with higher ( Energy Efficiency Ratio) but lower duty cycle and shorter life. Selection of compressor are based on the nature of application. Normally, for room A/Cs with capacity less than 3 ton, most companies offer rotary compressor due to it's EER and less duty cycle. For heavy duty A/Cs, recip or piston compressor best suited.
A rotary compressor is like a car engine, with pistons, rods, sleeves, valves, etc. A screw compressor has two screw type rotating parts that squeeze the refrigerant as the screw threads get tighter and tighter. They have long life potential.
try an air compressor.
Under the window washer tank
NO! the compressor has oil in the crankcase similar to a car. The compressor relies on among other things gravity to return the oil back. There are window shakers out there that will fit your application, just not this one.
acu compressor motor window type aircon 45 uf capacitor for 2.5 hp compressor 50 uf for 3 ton acu 60 uf for 1.5 hp compressor 35 uf
It could be due to cold temperatures, yes.
in the fuse box under the hood hood, next to the battery. It is a 40 ampere fuse
yes
Borrow a clamp on amp meter and check full load amps. If pulling full load amps then compressor condemned.
(from left to right) 1. 8 ampere turn signals, speedometer warning lights, fuel gauge 2. 8 ampere windshield wipers, brake warning light, automatic stick shift warning lights, rear window defroster switch 3. 8 ampere brake lights, horn 4. 8 ampere emergency flasher 5. 8 ampere unassigned 6. 8 ampere interior light, ignition buzzer 7. 8 ampere left high beam, high beam warning light 8. 8 ampere right high beam 9. 16 ampere left low beam 10. 8 ampere right low beam 11. 16 ampere left tail light 12. 8 ampere right tail light, side marker lights, license plate light http://www.thesamba.com/vw/archives/info/wiring/bug_7172_fuses.jpg
unplug it and let it thaw. The vent could be frozen over.