0
How much do you torque your intake manifold bolts on your 6.0?
Wiki User
∙ 12y ago
First step is 44in-Lbs . Second step is 89 in-Lbs. there is also a bolt tightening sequence you must follow for proper gasket sealing usually start from center one side then opposite side center and works from niddle out be get the chart it comes with gasket set
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the torquing specs for the bolts on a 1999 blazer 43 intake manifold The book gives 132 pounds but this seems too much?
I FOUND THIS AT WWW.AUTOZONE.COM, CLICK ON VEHICLE SPECS . For your 1999 CHEVROLET TRUCK BLAZER 2WD: INTAKE BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE LOWER MANIFOLD BOLTS TO 27 IN/LBS TORQUE LOWER BOLTS TO 9 FT/LBS TORQUE LOWER BOLTS TO 11 FT/LBS TORQUE UPPER MANIFOLD BOLTS TO 44 IN/LBS TORQUE UPPER MANIFOLD BOLTS TO 7 FT/LBS (TO TORQUE BOLTS & NUTS, START IN CENTER USING CRISSCROSS PATTERN)
How much torque should be aplied for the intake manifold?
Torque values are only listed in the vehicles repair manual or service manual and vary depending on year, make, and model.
How much torque a intake manifold need for a 2002 Chevy 1500?
for a Chevy 350 enginge its 25 to 30 ft lbs. cast iron heads.
What are the torque specs for a 1996 S10 Chevy Blazer intake manifold?
i checked with my brother who is a a.s.e. certified mechanic. it is 11 ft-lbs be sure to chase the threads with a tap and die set, and use locktite. to much torque will ruin the gasket, and not enough will cause a manifold leak.
How much is the torque of 2c cylinder head bolts Toyota?
torque for 2c engine cylinder head bolts
Where are the spark plugs on a 2000 Mitsubishi Galant v6 and can you change them without much trouble?
My 2002 Galant has not had spark plugs replaced for over 100k due to where they are. Three are underneath the intake manifold. Yes...intake has to be removed. Not difficult now that I know. Lots of bolts and hoses need to be removed to lift the manifold.
How much does intake manifold cost for a 1997?
$0 recall
What caused intake manifold to explode?
To much nitrous injected into it .
How much to replace a intake manifold on a grand marquis?
alot
How much would it cost to fix the manifold on a 2003 Ford Windstar?
Need to know if it is the intake manifold or an exhaust manifold and what is wrong with it.
How easy is it to change the intake manifold gasket on a 2000 SL2?
You really don't have much room to remove the intake itself where it stands. I hate to say it but you might have to remove the engine to do it. I would get a new gasket first and look at it. They may be cut to just slip in so if you just loosened all the intake bolts, you could slide the old one out and the new one in. The next problem will be accurately retorquing the intake manifold.
How much torque on 10 mm bolts?
65 LBS
