That will depend entirely on the make and year of the vehicle. I just recently bought a complete CV drive shaft for a 1997 Taurus and it cost me $ 89,
A drive shaft allows torque to enter a motor. Louis Renault of France was the inventor of the drive shaft. He invented the drive shaft in 1898.
is the drive shaft the same as the intermediate shaft on a vauxhall corsa car does any body no
The drive shaft is part of the drive train, not part of the transmission.
The rotational force supplied by a spinning shaft of steel (the drive shaft). If you look at the radius of the drive shaft which will be about two inches, and you look at how much power is supplied, you have what is called torque. It's how much power the lever arm, or radius of the drive shaft, can impart to the differential that controls the drive axle of the impelling wheel(s). The impelling wheel(s) are the wheel(s) that make the car go. They give the car traction.
Yes Drive Shaft is a real band.
The drive shaft connects the transmission to the differential.
tool for drive shaft
F150 4x4 drive shaft balanced
there is no drive shaft it's front wheel drive
The cost of the drive shaft repair varies. It really depends on what type of car you are driving and where you go. This repair can range any where from $40 to $100.
there is no dry shaft oly a crankshaft in the engine and the drive shaft that moves the car the drive shaft is connected to the transmission and the rear axle if your car is front wheel drive ypu do not have a drive shaft just a transmission and two axles
Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.