I would say it depends on were you go but just fitting will be labour cost £40 and hourly £10 all together £60 tops.
Its comes around £29.38
if its on a punto gt is a lot of work.have to remove inlet manifold costs a lots for the job to be done in a garage.
You have to go to a garage, which is usually at around £35 for it unfortunately.
This means you have a fault with your power steering. You should contact the garage as the power steering may fail.
You might want to check your lambda sensor, or distributor. Take it to a garage if you are unsure.
Your piston rings may be bad. Do a compression test to find out.
around 200 pound in a garage or you can buy clutch kit your self for around 60 pound!!
Possibly not The pipe in question is fitted to enable the engine to take in warm air during cold conditions. This reduces the chances of the carburettor freezing. If the fitting is on the manifold of your Punto air intake convoluted metal hoses are available at good accessory shops
you wanna go garage mate youl kill yaself lol
30psi
There is a good chance that the new belt has been fitted 'one tooth out'. The car will start up and run, but will misfire and will not accelerate very well. The garage who fitted the belt should rectify it free of charge. (should not cause any valve damage)
On a Fiat Punto, the sump plug is at the base of the sump. It should be a hexagonal fitment and somewhere between 12-13 mm. .