0
How much should it cost to replace a radiator in a Mitsubishi Lancer?
Wiki User
∙ 9y ago
It might cost as much as 600 dollars to replace the radiator in your Mitsubishi Lancer. This cost varies with the type of radiator that you choose and with your location.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How often should you change a timing belt on a Mitsubishi lancer?
I have a 2005 Mitsubishi Lancer, and my mechanic said it should be replaced every 50,000 to 60,000 miles.
How do you replace ac condenser in a 03 Mitsubishi eclipse?
Unscrew radiator, should be two attachments connected to condenser. Unscrew them from the condenser and it should slide right out from in front of the radiator.
What should be the tire pressure in Mitsubishi lancer 2002?
The tire pressure on a 2002 Mitsubishi Lancer should be between 30 and 35 PSI. This varies based on the size and type of tire.
What should it cost to replace an oxygen sensor on a Mitsubishi Lancer?
any were from a 100 dollars to 300 dollars. any were from a 100 dollars to 300 dollars.
How do you repair horn on a Mitsubishi lancer 2004?
To repair the horn on a Mitsubishi Lancer 2004 you should take your vehicle to the mechanic. You can also take it to the accredited dealer in the same.
When should Mitsubishi oz rally lancer timing belt be replaced?
60000 miles
What Should I buy 2009 Mitsubishi Lancer GT fully loaded OR 2009 Mazda 6 standard edition?
lancer gt. mazdas are crap
What is the Engine life on a Mitsubishi lancer?
With proper regular maintenance, you should be good for 200k miles.
What is the spark plug gap on a Mitsubishi lancer 1998 coup gli?
The spark plug gap on a 1998 Mitsubishi Lancer Coupe Gil should be set between .039 and .043 inches. This gap specification was set by the manufacturer.
Spark plug gapping for 2004 Mitsubishi lancer es?
it should say on the sticker under the hood
How do you replace a tail light on a Mitsubishi Lancer?
open the trunk and inside you should see the rear plastic panel of your lancer's tail lights. undo the screws(should be 3 screws/PC) using Philips screw driver and gently pull the assembly off. you should see 3 light bulbs. replace whichever is busted. make sure you install the correct bulbs for each socket.:) on an 03 lancer there are 2 screws and they are on the outside of the car when you open the trunk. remove then pull out assembly and change bulbs.
What is the bolt pattern for a 2003 Mitsubishi lancer Is is 4x100 or 4x114?
All Mitsubishi Lancers newer than 1993 models should be 4x100 I believe. I think the only exceptions are Mitsubishi Lancer VRX and EVO models, being 4x414. Refer to site listed in related links for a full list.
