get a high performance chip for the computer.
Go to YouTube and type in small engine govenor removal, good video of how to do this and other things!!!!!
under your truck their is a sensor that is mounted to the transmission that is a two pronged plug
just remove it and you are done... your s10 should push 130-140 plus
The engine speed governor is part of the computer programming and can not be removed.
yes the s10s were the same from 94 to 04 exept for the interior and grill change in 1997-1998
There is no speed governer, the car's powertrain control module is responsible for not only governing the speed, but making the car work.
What I believe your trying to ask is how to remove the drive shaft? If so than all you need is to remove the
The fan clutch on a 1997 S10 has a bolt on the center of the front. Remove the bolt while holding the clutch still. There is a special tool to grab the clutch fan from the rear to hold it while removing the bolt.
Yes, Sonny Perdue is a Republican, but he was a Democrat until 1998.
It has no governor. Speed is controlled by the computer.
You'll have to remove the driveshaft first.
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.
You can't take off the "governor" on any computerized car.
you need to get a power programer
It has no governor. Speed is controlled by the ECU.
check your answer
will 2002 monte carlo rims fit 2000 s10
Drain the water from your 1998 Chevrolet S 10 cooling system. Remove the water pump return hose. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
Does not have a governor. Speed is controlled by the ECU.
The 1998 and newer S10 with the 2.2L engine does not have a serviceable pcv valve.