Chevy S-10
Plymouth Sundance
Turn Signals and Hazard Lights
How To

How to install a flasher on a 1994 Plymouth sundance?

575859

Top Answer
User Avatar
Wiki User
Answered
2005-12-29 00:42:09
2005-12-29 00:42:09

I believe the flasher is up in, under the dash, to the right of the steering column. If it is, the best means to get to it is to remove the bezel for the radio and heater controls. At this point, depending upon exactly where it is, either the radio or heater control package must be slid out so you can reach the flasher. Not the most convenient place to put it.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do I change th starter on a 1994 Plymouth sundance

Remove the tire and wheel from your 1994 Plymouth Sundance. Remove the brake assembly spring. The brake pads will come off. Reverse the process to install the new brakes.

No, it is not an interference engine.

... on a 1990 Sundance there is a flasher just above and behind the radio - it seems to control the right side flashers. The 'bezel'type trim piece surrounding the section of the dash containing the radio can be pryed off. I would sure like to know where the flasher for the lights on the left side is ...

My child seat car bolt, is in a 1988 Sundance, passenger side about 1 ft from behind back seat, on trunk floor.

The codes on a 1994 Sundance are 2 digit codes. Code 3 is not correct.

You can purchase a dipstick from the dealer.

It is screwed into the exhaust manifold on the rear of the engine.

A 1994 Plymouth Sundance/Duster does not use a speedometer cable. Instead, it uses a Speed Sensor located on the transmission.

Front camber is adjusted at the strut to knuckle bolts.

On your 1994 PLYMOUTH ACCLAIM, the FLASHER is: FRONT SEATING AREA, PASSENGER SIDE, UNDER DASH, MOUNTED BEHIND GLOVE COMPARTMENT You can find this stuff free at autozone.com, repair info, component location.

It would greatly help to know what engine you have and if it has air conditioning (working or not)

Code 43 refers to the coil. Code 55 is end of message.

There are separate flasher relays for the hazard lights and turn signals. The flasher relay may be out on your blinkers. The relay for the hazards is behing the fuse box. The relay for the blinkers is behind the lower dash panel to the right of the steering column.

The engine computer is the rev limiter. It controls max rpm by shutting off fuel and ignition.

just follow the hose off the radiator that goes into your engine block. its on the front of the motor. you just loosen the 2 bolts that hold the hose on and its right there. very simple

behind drivers kick panel next to hood release

Please provide engine & tranny info, then maybe someone can help you with this.

Under hood, driver side, upper engine area, mounted on end of engine block

I just purchased a 1994 Plymouth sundance from my niegbor for dirt cheap (joe dirt) it has been sitting for about three years.just wanted to see if I could fire it up. put a new batt. in it . it cranks over but no fire I primed it with gas it fires and runs until gas burns out .I am thinking maybe a fuel pump from sitting so long! what do you think?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.