Want this question answered?
Jack the car up, loosen the bolts and remove the wheel. The next thing is to loosen the nuts joining the axle to the stath then remove the axle.
how to remove, or replace front right axle escape 2004
Either remove the trans, or remove the front axle on a 4x4.Either remove the trans, or remove the front axle on a 4x4.
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
First, remove the axle. Then, user a large screwdriver or a seal remover to remove the seal. Tap a new seal into place with a hammer. Reinstall the axle and fill the differential lubricant.
please tell me how to remove the bering and rotor?how do i get the answer?
It will come off over the front axle. Looks like it don't fit but it does. Unhook everything and it will slide out with some work.
Drive the car onto ramps then use a jack to raise the right axle and make some space between the axle and stablizer bar.
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
You will need to remove the tire and wheel from your 2002 Geo Tracker. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
First, remove the 8 bolts on the end of the axle (tire end). Next, use a special socket with 4 teeth that fit into the ratcheting nut and remove. The left side is reverse thread! The axle will now slide out easily. Be careful not to damage the rubber o-ring seal around the axle end itself.
Rear you have to change the entire hub assembly Front you have to remove the axle shaft