Want this question answered?
You can get one from Lindsay Driveline. 1-866-944-6288.
need information to removal of CV shaft from 2005 Mazda 3?
Im not sure which direction the bolt turns to remove the pulley...the crank shaft turns in clock wise direction when engine is running.
To the right of the crank shaft pulley. You should see a single black wire going up from the pulley. All you need is a 10MM socket to remove it.
remove tail shaft plate nut, pull shifters out from inside the car, then undo the bolts and it should come off easily enough.
?
MAZDA Tribute Alternator replacement V6This applies to the Mazda Tributes. To change the alternator; the factory procedure at the dealership says to drop the sub-frame from under the front of the vehicle. Then everything is accessible. This is not necessary.1. Remove the right front tire2. Remove dust pan from right front3. Remove the brake caliper and caliper bracket4. Remove the 2 bolts from the half shaft support bracket5. Remove the half shaft axle assembly6. Remove the serpentine belt7. Remove the 3 bolts holding the alternator in place8. Remove the 3 bolts holding the alternator mounting bracket9. Remove the alternator mounting bracket10. Remove the electrical connection on the alternator.11. The studs that are spot welded on the half shaft bracket will try to keep you from being able to remove the alternator. Put the nuts back on the studs until they are flush with the end. This will protect the threads while you take a straight bar long enough to get past the strut and knock out both studs from the bracket. They are only spot welded on the bracket.The alternator now has enough room by rotating and dropping down to remove through the opening.When re-installing the studs put lock washers on the back side and an O-ring on the front of them all the way up to the bracket so they will stay in place while you line up the axle bracket and get the nuts started.You are on your way to Getting 'ER Done".. !
To replace your CV joint you will have to slacken your hub nut before jacking and removing the wheel. Remove hub nut, remove both bolts on the bottom of the shocky, remove bottom ball joint bolt. You should have enough play to remove your shaft from the hub. Remove CV boot, CV joint should just pull off shaft. I made the mistake of buying and fitting a full drive shaft unnecessarily.
you dont! if you need that then you are buying a new cv shaft.
Yes it will
To remove the axle shaft, first remove the wheel, and brake drum/rotor. Second, remove the differental cover. Third, remove the bolt holding the spider gear shaft, and remove that shaft. Fourth push inward on the axle shaft to remove the horseshoe clip on the inside. The axle shaft will now pull out.
A WELL is a shaft in the ground used to remove groundwater